Subject:
|
Re: Train 3 Height and Width
|
Newsgroups:
|
lugnet.org.ca.rtltoronto
|
Date:
|
Fri, 11 Jan 2002 14:50:14 GMT
|
Viewed:
|
2147 times
|
| |
|
|
In lugnet.org.ca.rtltoronto, Calum Tsang writes:
> In lugnet.org.ca.rtltoronto, Jeff Van Winden writes:
> > Jeff, the clearence of my car is 29 - 30 inches.....
> >
> > How am i going to stack 3 modules in 30 inches..........
>
> well, think of it like this:
>
> Say you build your frames at 24 inches. That means 11 inches between the
> three holes. Put your taller modules as the bottom and middle, and your
> lowest module (ie, a flat, buildingless module) on the top. That way you
> get ~5-6 inches of clearance for the top module, and ~10-11 inches for the
> middle and bottom. Remember, the bottom of the module is open, so you can
> tuck the tops of buildings under the lip of the 1x2's...
>
> Calum
My problem is that all but one of my modules contain 2 story + buildings,
and they are almost all located on the side of a module....
I was figuring it out, and I do believe that it is possible.... I just have
to be absolutly sure that I drill the holes properlt.
The Mana's Idea is cool! (to lazy to post twice)
See ya tonight!
Jeff VW
Pretend that this message is interesting.....
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Re: Train 3 Height and Width
|
| (...) well, think of it like this: Say you build your frames at 24 inches. That means 11 inches between the three holes. Put your taller modules as the bottom and middle, and your lowest module (ie, a flat, buildingless module) on the top. That way (...) (25 years ago, 11-Jan-02, to lugnet.org.ca.rtltoronto)
|
21 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
