To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.cad.dev.org.ldrawOpen lugnet.cad.dev.org.ldraw in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 CAD / Development / Organizations / LDraw / 21
20  |  22
Subject: 
Re: [ldraw.org] Progress
Newsgroups: 
lugnet.cad.dev, lugnet.cad.dev.org.ldraw
Date: 
Thu, 3 Jun 1999 14:41:17 GMT
Viewed: 
44 times
  
On Thu, 3 Jun 1999 08:12:49 GMT, legoverse@geocities.com (Terry K) wrote:

[Good descriptions of inlining/MPD snipped]

If you want the files to be returned to a submodel state, MPD is better.
BUT - that requires splitting the MPD.

And if you use a ZIP archive, you have to unzip.  Unzipping is generally
more convenient than splitting an MPD, for the user.

But with MPD, a single file on the server can be used both for viewing and
for downloading.

...  The user would have to have LDlite installed to view [models from
the browser] ...

If you know how to set your browser, you can use LDraw to view from the
web.

I think that for an archive of models it is important to remember that, in
order for a user to easily build a model, the model should have subparts.
Trying to build a complex model from one single file is too difficult.  Using
subparts to break it down into stages or sections is desireable.  With that in
mind, the only choices are MPD or Zip files.  And, in my mind, Zip is a lot
easier and simpler.

Except that ZIP requires two files to be maintained: the ZIP and the
viewable file.  Well, the server could process the ZIP to send down the
X-LDraw DAT stream (did I say that right?).  But it's more work for the
server.

Steve



Message has 1 Reply:
  Re: [ldraw.org] Progress
 
(...) I think so too. (...) Then there is that. (...) Oops. Quite right. (...) That is assuming the file will be viewable online of course. Which would be a good idea. And, if it uses lugnet to archive them, will be just so. Hmm.... have the server (...) (25 years ago, 3-Jun-99, to lugnet.cad.dev, lugnet.cad.dev.org.ldraw)

Message is in Reply To:
  Re: [ldraw.org] Progress
 
(...) Info: --- Inlining: Inlining is generally considered a "one-way" process - though the inlined section can be manually cut out and pasted into a separate file if the beginning and end of the inlined section is known. It is directly viewable in (...) (25 years ago, 3-Jun-99, to lugnet.cad.dev, lugnet.cad.dev.org.ldraw)

39 Messages in This Thread:















Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR