| |
On Sat, 5 Jun 1999 03:09:01 GMT, "John VanZwieten" <john_vanzwieten@msn.com>
wrote:
> In lugnet.cad.dev, Steve Bliss writes:
> > Following up myself to resolve a dangling footnote...
> >
> > On Thu, 3 Jun 1999 14:14:19 GMT, blisses@worldnet.att.net (Steve Bliss)
> > wrote:
> >
> > > When LDAO inlines, it leaves a copy of the original line, commented out.
> > > But that's not a requirement of inlining, I just thought it was a
> > > reasonably good idea.[1]
> >
> > [1] In the next version of LDAO, the stand-alone inliner will allow you
> > better control over the inlining process. Specifically, there will be
> > options/buttons to:
> >
> > - Select all subfiles
> > - Unselect all
> > - Inline only models, submodels, and unofficial parts & primitives
> > - Keep or drop the original line
> > - Recurse through inlined code
>
>
> This will be great! Would there be any way to add an option to leave out the
> file information comments lines of subfiles (or maybe just all comments) when
> inlining? If you use several levels of subparts when creating a part, then
> inline it, it takes a while to delete all those cumbersome comment lines.
>
> -John Van
I agree. It would be nice to have the capability to do a 'clean' inline.
-- Terry K --
|
|
Message is in Reply To:
39 Messages in This Thread:
  
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
