Subject:
|
Re: Voting page 9905
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Wed, 2 Jun 1999 16:39:42 GMT
|
Reply-To:
|
JSPROAT@GEOCITIES.COMnospam
|
Viewed:
|
815 times
|
| |
|
|
Steve Bliss wrote:
> On Tue, 1 Jun 1999 16:57:14 GMT, Sproaticus <jsproat@geocities.com> wrote:
> > 6222 - (MINOR) There are some extra lines on the bottom of this piece,
> > reaching from a single side of the 4 cardinal half-cylinders to the outside
> > edge of the piece.
> I'm not seeing these. Of course, it took me about 5 minutes to figure out
> how you were viewing this piece in LEdit, since the part-file has almost
> 1500 lines.
:-S Oops. I can be more specific (but it's really a minor issue):
I am viewing it in LEdit at 2x magnification, at the underside. Underneath,
you see the center cylinder, with four sets of two half-cylinders forming a
cross around it. The split in each set of two half-cylinders is
perpindicular to a line drawn through this set and the center cylinder.
In this view, look at the set of two half-cylinders nearest to top of the
screen. Reaching from the right-hand side of the split, and extending
vertically to the edge of the piece, is a solid line. This also occurs in
the other three, in a radial symmetry. I'm guessing that 1 / 4 of this part
was made, then three copies of it were rotated and inlined into the master
part file; if that's the case, it's probably a one-line fix in the original
sub-part.
Cheers,
- jsproat
--
Jeremy H. Sproat <jsproat@geocities.com>
http://www.geocities.com/SiliconValley/Horizon/5249/
May the Force be with y'all.
|
|
Message is in Reply To:
 | | Re: Voting page 9905
|
| (...) Hmm. Why not, indeed? (...) I'm not seeing these. Of course, it took me about 5 minutes to figure out how you were viewing this piece in LEdit, since the part-file has almost 1500 lines. Steve (25 years ago, 2-Jun-99, to lugnet.cad.dev)
|
27 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
