Subject:
|
Re: LSynth within LPub
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Thu, 20 Oct 2005 01:19:39 GMT
|
Viewed:
|
1382 times
|
| |
|
|
In lugnet.cad, Kevin L. Clague wrote:
>
> Actually, what I need to do first is release the new LSynth. The issue that is
> holding me up is that I no longer want to ship synthesis specific parts (not
> real parts), with the LSynth release. The parts have all been put in the parts
> tracker.
>
> I have to make up a list of the parts needed, and build a table of pointers to
> them on the LDraw sight.
Dunno how hard it is, but I think there needs to be a way to specify the
"bendiness" of the hoses. I know I've had problems with it before which you
whipped up a quick fix for (thanks!) but I just ran into a similar problem
trying to do the hoses on the top of the ladder here
http://www.brickshelf.com/gallery/RoscoHead/trains/shay/side_r.jpg it's not
bendy enough. Maybe there should be a default "bendiness" for each type, but
allow it to be adjusted with a param on the SYNTH BEGIN line?
ROSCO
|
|
Message has 1 Reply:
 | | Re: LSynth within LPub
|
| (...) I was hoping that bendiness was based on hose type, but alas I think it is not. Might you want it on a segment by segment basis? I'll have to figure out what units to use. First I've got to get something released. Kev (...) (19 years ago, 20-Oct-05, to lugnet.cad)
|
Message is in Reply To:
| | Re: LSynth within LPub
|
| (...) The lsynth you run from inside LPub is the same one you run from inside MLCad. I'll see what I can do when I get home. Actually, what I need to do first is release the new LSynth. The issue that is holding me up is that I no longer want to (...) (19 years ago, 19-Oct-05, to lugnet.cad)
|
17 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
