Subject:
|
Re: motorized points - beating a dead horse
|
Newsgroups:
|
lugnet.trains, lugnet.robotics
|
Date:
|
Sun, 3 Dec 2000 05:33:06 GMT
|
Viewed:
|
2362 times
|
| |
|
|
Great tip, I never thought about using multible pulley/rubber bands! A big
problem is the detent, the two at rest positions are very "sticky". Naybe
more then multible rubber bands can even move. I'll give it a try.
SteveB
In lugnet.trains, Juergen Stuber writes:
> "sebarile-MOBL" <steve.e.barile@intel.com> writes:
> >
> > Currently I am attempting to build an automated hump yard. The main problem
> > I'm tackling is the RCX controlled motorized points. I've spent 7 hours over
> > the last two days trying to build a motorized switch track that will run
> > forever with out ripping itself off the base plates and be very *forgiving*
> > at the edges of both states, turn or straight. What I mean by forgiving is
> > that the motor doesn't burn up or the gears do not get stripped off.
> >
> > I like really simple and elegant solutions. For instance I would like to be
> > CPU switched with no feedback, again forgiving at the edges of both states
> > such that the motor can spin for 1.5 secs and not reap havoc. Hanging
> > elaborate clutch systems with differentials and angle sensors would not be
> > my first choice. Of course beggers can't be choosers.
>
> I'm not exactly sure about your setup (I'm not into trains),
> but how about a small pulley (half bushing) on the motor,
> driving a medium pulley (with the six holes) on an axle on
> whose other end is an 8t gear that drives a rack.
> That setup works well for rack and pinion steering,
> where you have similar problems.
> If one pulley/rubber band is not enough you can put another one
> in parallel (like in 8480), or you can experiment with the tension
> of the rubber bands.
>
> Jürgen
|
|
Message has 1 Reply:
 | | Re: motorized points - beating a dead horse
|
| (...) I made a design that used a clutch gear and fit into a house. It worked very well when the switch was "warm" but wouldn't always trip it when it had been sitting for a bit. But it allowed the throw arm to fully though the switch one way or the (...) (24 years ago, 3-Dec-00, to lugnet.trains, lugnet.robotics)
|
Message is in Reply To:
22 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
