Subject:
|
Re: DCC slowing?
|
Newsgroups:
|
lugnet.trains
|
Date:
|
Thu, 14 Aug 2003 00:28:26 GMT
|
Viewed:
|
3080 times
|
| |
|
|
In lugnet.trains, John C. Moore wrote:
> I have a question abuot DCC. I was first exposed to DCC at our last LUG meeting
> where some of the motors had been modified. They were running 2 motors on the
> track on different channels. Then we placed the two motors on the same channel
> and placed them on my train (which requires 2 motors). The results were
> nice...for a while. It ran quite nicely for maybe 10 minutes, but then it
> started slowing in the corners...especially in two corners that were diagonal of
> each other on the oval. It continued to go slower and slower until it came to a
> stop in these corners and simply was acting like it had no power. Has anyone
> else had this problem and what is the cause? Over heating?
What was supplying the power to the track? An RCX or a commercial DCC
controller? If an RCX running LDCC, it may have been the RCX over heating.
ROSCO
|
|
Message has 1 Reply:
 | | Re: DCC slowing?
|
| (...) The track was powered by a RCX. Also we only had 1 engine running and experienced this problem. mark (23 years ago, 14-Aug-03, to lugnet.trains)
|
Message is in Reply To:
| | DCC slowing?
|
| I have a question abuot DCC. I was first exposed to DCC at our last LUG meeting where some of the motors had been modified. They were running 2 motors on the track on different channels. Then we placed the two motors on the same channel and placed (...) (23 years ago, 13-Aug-03, to lugnet.trains)
|
31 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
