| |
In lugnet.robotics.rcx, Mark Riley wrote:
<snip>
> I did however, add a diode in parallel with the lamp output
> in case I decide to run an inductive load such as a
> relay or motor on the lamp output.
>
> One thing to note, since the DCC decoder drops the voltage
> somewhat, the actual train motor is only seeing about 7V. This
> means the locomotives aren't as zippy as with the standard
> train regulator. Nonetheless, if you're operating a few trains with
> 5-6 cars each, it shouldn't be a problem. For a large club layout,
> an external booster is probably advisable, though.
>
> Cheers,
>
> Mark
Mucho appreciated Mark.
The Diode--any diode will do? and just solder it across the connector output?
Take care,
Dave
|
|
Message has 1 Reply:
 | | Re: DCC for the RCX
|
| (...) output? Dave, I used a 1N4002. It's a fairly common 1 amp switching diode. Here's a picture from my latest decoder install: (URL) that the banded end of the diode gets the blue lead from the decoder. The unbanded end gets the white lead. If (...) (23 years ago, 28-May-03, to lugnet.robotics.rcx, lugnet.trains)
|
Message is in Reply To:
| | Re: DCC for the RCX
|
| (...) I (...) resistors (...) goes (...) run (...) the (...) isn't (...) reduce the (...) David, When I installed my first decoders (Digitrax DN121), I omitted the capacitors, figuring if the buzzing was annoying, I could always add them later. As (...) (23 years ago, 28-May-03, to lugnet.robotics.rcx, lugnet.trains)
|
35 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
