Subject:
|
One-tenth stud offsets (was Re: Retraction about offset stud on box cars)
|
Newsgroups:
|
lugnet.trains
|
Date:
|
Wed, 4 Jul 2001 21:12:37 GMT
|
Viewed:
|
1153 times
|
| |
|
|
In lugnet.trains, Jake McKee writes:
> In lugnet.trains, Jason J. Railton writes:
>
> > By the way, I can now do 1/10 stud offsets! It's a bit small to look any
> > good, but it's possible. You use a 2x1 plate with centre stud. That sets
> > you 1/2 a stud, or 5/10, back from the normal row of studs. Then you fit a
> > technic twin-hole brick on that with a plate pushed into the side, which is
> > 2/5 (or 4/10) of a stud out. So, 5/10 - 4/10 = 1/10. Then, use short pins
> > in the side of another technic twin-hole brick, or a 2x1 hinge brick, to
> > attach your wall to the plate. This might be hard to fit in 6-wide though.
>
> Can you post some pics? I would love to see this!!
>
> Jake
Right, take a look at these pictures. I've set up a row of 1x2 bricks, each
set 1/10 of a stud further back than the last:
<http://www.joefish.cwc.net/tenths>
Anything from 1/10 to half a stud of recess could be concealed inside a
6-wide wagon.
Jason J Railton
|
|
Message has 1 Reply:
Message is in Reply To:
17 Messages in This Thread:
 
   
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
