Subject:
|
Re: Retraction about offset stud on box cars and stuff
|
Newsgroups:
|
lugnet.trains
|
Date:
|
Wed, 4 Jul 2001 15:56:32 GMT
|
Viewed:
|
967 times
|
| |
|
|
In lugnet.trains, Jason J. Railton writes:
> By the way, I can now do 1/10 stud offsets! It's a bit small to look any
> good, but it's possible. You use a 2x1 plate with centre stud. That sets
> you 1/2 a stud, or 5/10, back from the normal row of studs. Then you fit a
> technic twin-hole brick on that with a plate pushed into the side, which is
> 2/5 (or 4/10) of a stud out. So, 5/10 - 4/10 = 1/10. Then, use short pins
> in the side of another technic twin-hole brick, or a 2x1 hinge brick, to
> attach your wall to the plate. This might be hard to fit in 6-wide though.
Can you post some pics? I would love to see this!!
Jake
---
Jake McKee
AFOL
LUGNET Member #211
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Re: Retraction about offset stud on box cars and stuff
|
| (...) Ah, I get it now. Very subtle. By the way, I can now do 1/10 stud offsets! It's a bit small to look any good, but it's possible. You use a 2x1 plate with centre stud. That sets you 1/2 a stud, or 5/10, back from the normal row of studs. Then (...) (23 years ago, 4-Jul-01, to lugnet.trains)
|
17 Messages in This Thread:
   
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
