Subject:
|
Re: Connecting New Cylinders
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Fri, 12 Dec 2003 18:12:20 GMT
|
Viewed:
|
1547 times
|
| |
|
|
In lugnet.technic, Jonathan MacIntyre wrote:
| |
Hello
I am trying to connect two of the new form factor cylinders back-to-back. Does
any one have any ideas? I wish only to use lego parts.
Thanks
|
Well, I don’t have any of the new pistons so this may not work, but have a look
at this setup (click for larger view):
With the new pistons, you should be able to use the new 1x2 liftarms instead.
To get the liftarm to seat properly over the tubing, tug on the tubing while
sliding the liftarm closer to the piston. My only concern is that this may
exert to much lateral pressure on the piston inlet if the load is too great. Ye
be warned... :-)
Mark
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Connecting New Cylinders
|
| Hello I am trying to connect two of the new form factor cylinders back-to-back. Does any one have any ideas? I wish only to use lego parts. Thanks (21 years ago, 12-Dec-03, to lugnet.technic)
|
21 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
