Subject:
|
Re: Connecting New Cylinders
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Fri, 12 Dec 2003 20:12:44 GMT
|
Viewed:
|
1540 times
|
| |
|
|
In lugnet.technic, Mark Riley wrote:
| |
In lugnet.technic, Jonathan MacIntyre wrote:
|
| |
With the new pistons, you should be able to use the new 1x2 liftarms instead.
|
It works very well!
Philo
|
|
Message has 2 Replies:
 | | Re: Connecting New Cylinders
|
| (...) I knew it would be a hassle to connect this new cylinder back-to-back! Too bad TLC did not put an axle hole in it :( I must say Mark's version looks like a winner (right until the inlet pops off :) )! -- Best regards, /Tobbe (URL) (remove SPAM (...) (21 years ago, 17-Dec-03, to lugnet.technic, FTX)
|
Message is in Reply To:
| | Re: Connecting New Cylinders
|
| (...) Well, I don't have any of the new pistons so this may not work, but have a look at this setup (click for larger view): (URL) With the new pistons, you should be able to use the new 1x2 liftarms instead. To get the liftarm to seat properly over (...) (21 years ago, 12-Dec-03, to lugnet.technic, FTX)
|
21 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
