Subject:
|
Re: Connecting New Cylinders
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Wed, 17 Dec 2003 12:33:07 GMT
|
Viewed:
|
1666 times
|
| |
|
|
In lugnet.technic, Philippe Hurbain wrote:
| |
In lugnet.technic, Mark Riley wrote:
| |
In lugnet.technic, Jonathan MacIntyre wrote:
|
| |
With the new pistons, you should be able to use the new 1x2 liftarms
instead.
|
It works very well!
|
I knew it would be a hassle to connect this new cylinder back-to-back! Too bad
TLC did not put an axle hole in it :(
I must say Mark’s version looks like a winner (right until the inlet pops off :)
)!
--
Best regards,
/Tobbe
http://www.lotek.nu
(remove SPAM when e-mailing)
|
|
Message has 1 Reply:
 | | Re: Connecting New Cylinders
|
| i'm just curious is it possible to put piston's vents inside the axlehole? if yes then maybe the rest of vent will stick out enough to still join the tube hmm? pixel "Tobbe Arnesson" <StPnAtM@lotek.nu> wrote in message news:Hq1HJ7.rDH@lugnet.com... (...) (21 years ago, 17-Dec-03, to lugnet.technic)
|
Message is in Reply To:
21 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
