Subject:
|
Re: Connecting New Cylinders
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Wed, 17 Dec 2003 13:58:15 GMT
|
Viewed:
|
1704 times
|
| |
|
|
i'm just curious
is it possible to put piston's vents inside the axlehole?
if yes then maybe the rest of vent will stick out enough to still join the tube
hmm?
pixel
"Tobbe Arnesson" <StPnAtM@lotek.nu> wrote in message news:Hq1HJ7.rDH@lugnet.com...
> In lugnet.technic, Philippe Hurbain wrote:
> > In lugnet.technic, Mark Riley wrote:
> > > In lugnet.technic, Jonathan MacIntyre wrote:
> >
> > > With the new pistons, you should be able to use the new 1x2 liftarms
> > > instead.
> >
> > It works _very_ well!
> >
> > <<http://www.brickshelf.com/gallery/Philo/Misc/2pistons.jpg>>
>
> I knew it would be a hassle to connect this new cylinder back-to-back! Too bad
> TLC did not put an axle hole in it :(
>
> I must say Mark's version looks like a winner (right until the inlet pops off :)
> )!
>
> -- ¬
> Best regards,¬
> /Tobbe¬
> <http://www.lotek.nu>¬
> (remove SPAM when e-mailing)
|
|
Message has 2 Replies:
 | | Re: Connecting New Cylinders
|
| Hi Pixel, (...) Yes, they fit perfectly (...) Unfortunately no, the pneumatic tube is very loose on the remaining part of the vent :( Philo (21 years ago, 17-Dec-03, to lugnet.technic)
|
Message is in Reply To:
| | Re: Connecting New Cylinders
|
| (...) I knew it would be a hassle to connect this new cylinder back-to-back! Too bad TLC did not put an axle hole in it :( I must say Mark's version looks like a winner (right until the inlet pops off :) )! -- Best regards, /Tobbe (URL) (remove SPAM (...) (21 years ago, 17-Dec-03, to lugnet.technic, FTX)
|
21 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
