Subject:
|
Re: NQC 2.1 b2 in beta test
|
Newsgroups:
|
lugnet.robotics.rcx.nqc
|
Date:
|
Fri, 14 Jan 2000 02:05:45 GMT
|
Viewed:
|
4861 times
|
| |
|
|
In article <dn6s7sguu1c9b80p398tsgkjcsp6ltdisr@4ax.com>, donc@cccd.edu wrote:
> dbaum@spambgoneenteract.com (Dave Baum) wrote:
> >
> > I don't see any reason why you wouldn't be able to copy the beta version
> > of NQC on top of the one RcxCC normally invokes.
> >
> > I suspect Mark will update RcxCC shortly after 2.1 becomes final.
>
>
> The beta does not seem to work with RcxCC. All it does is display the
> parameters for NQC and then exits. No compile.
> ---
> DonC
> donc@cccd.edu
Hmmm - the only reason I can think of for this would be if RcxCC is using
one of the deprecated options that were removed in 2.1 (-o, -e, and -s
which were replaced by -O, -E, and -S). If Mark can confirm which (if
any) of these options are being used, I can hold off eliminating them
until 2.2. However, they've been deprecated for several releases now and
I want to clear them out if possible.
Dave Baum
--
reply to: dbaum at enteract dot com
|
|
Message has 1 Reply:
 | | Re: NQC 2.1 b2 in beta test
|
| (...) The same problem was already present with the b1 (I had asked about it in this newsgroup but got no reply). Also, I don't think it is related to the parameters. I have now checked the exec call of RcxCC with a debugger and found this is the (...) (27 years ago, 14-Jan-00, to lugnet.robotics.rcx.nqc)
|
Message is in Reply To:
25 Messages in This Thread:
 
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
