Subject:
|
Re: r/c servos
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Fri, 20 Aug 1999 20:57:11 GMT
|
Original-From:
|
"Keith Miller" <kmiller@talon.net>
|
Viewed:
|
972 times
|
| |
|
|
okay.. how about this..
avg servo needs..
60hz pulses..
1.0ms pulse width = end point
1.5ms pulse width = middle of rotation
2.0ms pulse width = other end point
that is the form of the data to the servo.
so you need to out put pulses 60 times a second, and vary the pulse width
from 1.0 ms to 2.0 ms
----- Original Message -----
From: Robert Munafo <munafo@gcctechNO.SPAMcom>
To: <lego-robotics@crynwr.com>
Sent: Friday, August 20, 1999 4:34 PM
Subject: Re: r/c servos
> In lugnet.robotics, lego-robotics@crynwr.com (John Barnes) writes:
> > [...] This would set the average servo, which needs a pulse from about
> > 0.7 - 2.0 mS for 180 degress to one of about 45 steps or every 5 degrees
> > [...]
>
> I can't understand this. Can you correct your grammar so it is clear what
> you're saying the average servo needs?
>
> - Robert Munafo http://www.mrob.com
> LEGO: TC+++(8480) SW++ #+ S-- LS++ Hsp M+ A@ LM++ YB64m IC13
> --
> Did you check the web site first?: http://www.crynwr.com/lego-robotics
--
Did you check the web site first?: http://www.crynwr.com/lego-robotics
|
|
Message is in Reply To:
 | | Re: r/c servos
|
| (...) I can't understand this. Can you correct your grammar so it is clear what you're saying the average servo needs? - Robert Munafo (URL) LEGO: TC+++(8480) SW++ #+ S-- LS++ Hsp M+ A@ LM++ YB64m IC13 (25 years ago, 20-Aug-99, to lugnet.robotics)
|
20 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
Active threads in Robotics
|
|
|
|
|
|
