 | | Re: Steering a robot
|
|
(...) I have two designs that use separate steering and propulsion motors: (URL) (28 years ago, 12-Apr-99, to lugnet.robotics)
|
| |
 | | Re: **lego motors?**
|
|
Use the "differtrans." See (URL) OR AT (URL) M. Tonkens, M.D. Medical Director Primary Care of Nevada 100 North Green Valley Parkway Suite 240 Henderson, NV 89014 702 914-7120 VOICE 702 914-7129 FAX BMajik5127@aol.com (...) RMT -- Did you check the (...) (28 years ago, 12-Apr-99, to lugnet.robotics)
|
| |
 | | Re: Steering a robot
|
|
Thanks to everyone that responded. I do indeed have a differential setup on the rear wheels and a second differential to incorporate the power of two motors. The steering problem is that I don't know how to reset the steering wheels on the front of (...) (28 years ago, 12-Apr-99, to lugnet.robotics)
|
| |
 | | Re: Steering a robot
|
|
(...) On one of my robots I have a light sensor that I use the third motor to scan to the left and right. I use a single touch sensor and two cams such that it knows when it has reached either extreme. Using the Fwd(), Rev(), and Off() routines will (...) (28 years ago, 12-Apr-99, to lugnet.robotics)
|
| |
 | | Web site update
|
|
I have up dated my site with my Senior project that I built out of my lego mind stormes. Check it out (URL) on the senior project link Download Neoplanet at (URL) you check the web site first?: (URL) (28 years ago, 13-Apr-99, to lugnet.robotics)
|
| |
 | | Re: Steering a robot
|
|
(...) This is a good starting point for a gear system that uses one motor to drive both wheels, and another that adds and subtracts rotations from the wheels to produce turning. (URL) subject has been covered a lot in earlier messages, so it may be (...) (28 years ago, 12-Apr-99, to lugnet.robotics)
|
| |
 | | wall-follower using Dennis Clark's IRPD
|
|
Earlier this year I tried building a wall-follower using RCX's built-in IR port as the proximity detector. However I could not get consistent readings from the light sensor to make it work. I thought it was because the SendMessage trick did not turn (...) (28 years ago, 12-Apr-99, to lugnet.robotics)
|
| |
 | | clutch gear
|
|
Is the motor kit the only way to get a clutch gear? Joel Shafer joel@connect.net -- Did you check the web site first?: (URL) (28 years ago, 12-Apr-99, to lugnet.robotics)
|
| |
 | | Re: clutch gear
|
|
(...) No, but it's probably the cheapest, unless it's in a Dacta spare parts kit I don't know about. Target had the 3735s on sale for over 50% off. It's also in the 8479 Bar Code Multi set, but that's $160. These are the only two sets that have it (...) (28 years ago, 13-Apr-99, to lugnet.robotics)
|
| |
 | | Dark seeker project
|
|
I have finally built a creation with my Mindstorms kit that uses all of the sensors (some twice) and all of the motor connections! It has two bump switches for a collision detector on the front, one of my RCX IRPD modules to try to detect potential (...) (28 years ago, 13-Apr-99, to lugnet.robotics)
|
| |
 | | Re: **lego motors?**
|
|
(...) I don't think that it would take up a lot of space at all. In fact, the largest part should be the motor that is used to engage/disengage the gear. Using a tractor hub, two 16-T gears, and two axles (with other parts to hold this all together, (...) (28 years ago, 13-Apr-99, to lugnet.robotics)
|
| |
 | | Re: **lego motors?**
|
|
Laurentino Martins wrote in message <4.1.19990412164203....90.220>... (...) gears, with a rubber band pushing it to one of the sides...? There has been a couple of versions of just what you describe, however I don't have the URLs. Sorry... about (...) (28 years ago, 13-Apr-99, to lugnet.robotics)
|
| |
 | | just to say hi
|
|
hi (28 years ago, 13-Apr-99, to lugnet.robotics)
|
| |
 | | Re: clutch gear
|
|
(...) What's the clutch gear? Is it the same as the free-wheeling gear which comes in one of the Lego service packs? (either the diff one or the gear blocks one, I forget which) If not, could someone describe it? Stuart -- Did you check the web site (...) (28 years ago, 13-Apr-99, to lugnet.robotics)
|
| |
 | | RE: clutch gear
|
|
# From: sc10003@eng.cam.ac.uk # Sent: Tuesday, April 13, 1999 01:47 PM # To: lego-robotics@crynwr.com # Subject: Re: clutch gear # ---...--- # What's the clutch gear? Is it the same as the free-wheeling gear which # comes in one of the Lego service (...) (28 years ago, 13-Apr-99, to lugnet.robotics)
|
| |
 | | Lego Bots in Germany???
|
|
Hello List! It seems that Lego refuses to sell the Mindstorms Roboticcs Invention Kit to non-English-speaking countries, allegedly because they don't want to annoy us with an English manual?! The only robotics set available in Germany is this Lego (...) (28 years ago, 13-Apr-99, to lugnet.robotics)
|
| |
 | | Re: Lego Bots in Germany???
|
|
(...) Remember, this was supposed to be a kids product. (...) CyberMaster. And you are lucky because you are the only country that sells with an aluminium box, the other countries sell it in a card box. (...) Try these: Mondo-tronics' Robot Store (...) (28 years ago, 13-Apr-99, to lugnet.robotics)
|
| |
 | | Re: Lego Bots in Germany???
|
|
(...) The same in Italy where I live. (...) Mindstorm is, IMHO, absoulutely worth to buy. You can find it at $219 (if I remember well) at www.legoworldshop.com. They're not cheap but accept credit card, ship worldwide and have a very good service. (...) (28 years ago, 13-Apr-99, to lugnet.robotics)
|
| |
 | | Re: Lego books?
|
|
you can pre-order "the art of robotics: an introduction to engineering" at amazon.com -ben (...) (28 years ago, 13-Apr-99, to lugnet.robotics)
|
| |
 | | Re: Steering a robot
|
|
(...) One of my bots uses a sensos to center the steer. It turns the wheels right or left putting steering motor on for a while, and when it's time to center the wheels back it uses a sensor to check the central position. I also suggest you use a (...) (28 years ago, 13-Apr-99, to lugnet.robotics)
|