 | | Re: Might be new to Mindstorms
|
|
The set is a good value. It provides a generous supply of technic parts to get you started. Later on add RoboSports. Then you will be hooked. Your building skills should make some interesting bots. Hope you will share them with us. -- Bob Fay The (...) (28 years ago, 27-Feb-99, to lugnet.robotics)
|
| |
 | | Re: Might be new to Mindstorms
|
|
Ok.. I checked that out... from the sounds of it the RIS is the better bet... Bascially it sounds like Cybermaster is like the RC they sold in the I think summer cat from S@H??? only it's computer controlled instead of hand remote controlled? I will (...) (28 years ago, 27-Feb-99, to lugnet.robotics)
|
| |
 | | More questions
|
|
On the official Lego Mindstorms website, they say that the first 2 slots are locked, you can't d/l anything to them.. are you able to unlock these and use these? or are you stuck with only 3 slots out of 5? it does mention you can set which slots (...) (28 years ago, 27-Feb-99, to lugnet.robotics)
|
| |
 | | Re: More questions
|
|
Not sure about other software packages but the Dacta\RoboLab software allows you to unlock the slots for programs 1&2. As Far as sensors in the Dacta/Pitsco catalog they run from $11.00 to $27.00. But there is plenty of information about maning some (...) (28 years ago, 27-Feb-99, to lugnet.robotics)
|
| |
 | | Visual Basic and GetStarted program
|
|
When I load the GetStarted program into the RCX with Visual Basic, the program becomes locked into any program slot I put it. This does not happen with other programs. Any one know what is in the GetStarted program that is causing this and what can (...) (28 years ago, 28-Feb-99, to lugnet.robotics)
|
| |
 | | Re: More questions
|
|
(...) Yes! (...) Yes! (...) Yes! But special programming may be required. Look at earlier postings here with several solutions/ideas for putting more than one sensor on a slot. (...) Yes! When reading your questions I think you want this kit. Play (...) (28 years ago, 28-Feb-99, to lugnet.robotics)
|
| |
 | | Re: list/group merge (was RE: Newbie Question.. FAQ?
|
|
Kekoa Proudfoot wrote: snip (...) What's a Handy Board? Gordie -- "It is better to ask a 'stupid question' than to make a stupid mistake." (28 years ago, 28-Feb-99, to lugnet.robotics)
|
| |
 | | Robolab COM Ports
|
|
I am running Robolab and Mindstorms on the same PC (WIN95). I have a modem on COM1 and a touch pad on COM2. In Mindstorms I connected the RCX transmitter to COM4 - but in Robolab the set-up screen only lists COM1 or COM2 as options. So using Robolab (...) (28 years ago, 28-Feb-99, to lugnet.robotics)
|
| |
 | | Slope in NQC
|
|
Hi Everyone, Can anyone tell me what is the NQC equivalent of the slope parameter in the Spirit.OCX SetSensorMode command. Thanks, David Strike -- Did you check the web site first?: (URL) (28 years ago, 28-Feb-99, to lugnet.robotics)
|
| |
 | | Re: Slope in NQC
|
|
(...) Making mine Dave Baun's words: I think you can already change the slope with the existing calls. Just add the slope to the mode constant... SensorMode(IN_1, SMODE_BOOL + 10); The slope should be between 0 and 31 (inclusive). :-) Laurentino (...) (28 years ago, 28-Feb-99, to lugnet.robotics)
|
| |
 | | Problem with VB an cybermaster
|
|
Hi Seems that I am a litle bit stupid. I am fighting with Visual Basic the first time. I want to program my Cybermaster. If I press alive I get correctly that the Cybermaster is turned on. But if I press Battery I get the errormessage "can not (...) (28 years ago, 28-Feb-99, to lugnet.robotics)
|
| |
 | | Re: Robolab COM Ports
|
|
What about getting a switch box so you can go back and forth. Jim Clark (...) This message was sent from Bess.Net, a filtered Internet Access Provider for children and families. ---...--- -- Did you check the web site first?: (URL) (28 years ago, 28-Feb-99, to lugnet.robotics)
|
| |
 | | Re: A walking robot with (only) two legs
|
|
Andrew , (...) In its present configuration it is stable and strong enough. If you want to extend its height and weight, you have to compensate this adding more weight on the "sling", or better making it move further more "out" to the right and the (...) (28 years ago, 28-Feb-99, to lugnet.robotics)
|
| |
 | | Re: Problem with VB an cybermaster
|
|
you need to make sure it's setup for the cybermaster.. it defaults to a RCX I think. -----Original Message----- From: Stefan Prescher <prescher@hermes.fho-emden.de> To: lego-robotics@crynwr.com <lego-robotics@crynwr.com> Date: Monday, March 01, 1999 (...) (28 years ago, 28-Feb-99, to lugnet.robotics)
|
| |
 | | Re: Problem with VB an cybermaster
|
|
Stefan Prescher wrote in message ... (...) brick (...) You left out the opening ceremonies. See (URL) Brok (28 years ago, 1-Mar-99, to lugnet.robotics)
|
| |
 | | Re: Might be new to Mindstorms
|
|
Mookie wrote in message <36D831C7.78D50CF5@e...pc.com>... (...) Both RIS and Cybermaster are much more versatile than RC and Barcode Pilot. The RC car isn't good for anything else but RC controlling a car and even limited in that too (no variable (...) (28 years ago, 1-Mar-99, to lugnet.robotics)
|
| |
 | | Inchworm
|
|
Pointless Invention Of The Week: I've put together a Lego "inchworm" using the MindStorms RIS and a few more pieces. Utterly silly, good for a chuckle or two. Pictures at: (URL) has no sensors, and it uses the RCX as nothing but a dumb battery box. (...) (28 years ago, 1-Mar-99, to lugnet.robotics)
|
| |
 | | Machina Speculatrix Reproduction
|
|
Over fifty years ago W. Grey Walter started building three wheeled, turtle like, mobile robotic vehicles. These vehicles had a light sensor, touch sensor, propulsion motor, steering motor, and a two vacuum tube analog computer. Even with this simple (...) (28 years ago, 2-Mar-99, to lugnet.robotics)
|
| |
 | | Re: Machina Speculatrix Reproduction
|
|
Great post! Thanks. - - - Nick - - - Michael Gasperi wrote: <snip> (...) (28 years ago, 2-Mar-99, to lugnet.robotics)
|
| |
 | | Re: Inchworm
|
|
Just when you think you have seen it all! This is really clever. -- Bob Fay The Shop (URL) Beatty wrote in message <36DB08C6.4CBE15B8@a...sk.com>... (...) (28 years ago, 2-Mar-99, to lugnet.robotics)
|