Subject:
|
Re: Power Supply & v3
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Wed, 1 Sep 2004 21:07:13 GMT
|
Viewed:
|
2534 times
|
| |
|
|
In lugnet.robotics, Ted Michon wrote:
> In lugnet.robotics, <liz@bookwyrmz.com> wrote:
> > What power supply does the RCX take? Can it use the LEGO train power
> > supply (Train Speed Regulator Power Adaptor 120V 60Hz)? I know this
> > somewhere, but I'm in the middle of a brain spasm.
>
> The 1.0 RCX's run nicely on the train regulator's AC cube which puts out 9+
> volts AC. (You could also run DC into the RCX if you like, since there's an
> on-board full wave bridge rectifier).
>
> -Ted
I've been using the ControlLab AC Adapter. Works quite well.
|
|
Message is in Reply To:
 | | Re: Power Supply & v3
|
| (...) The 1.0 RCX's run nicely on the train regulator's AC cube which puts out 9+ volts AC. (You could also run DC into the RCX if you like, since there's an on-board full wave bridge rectifier). -Ted (20 years ago, 1-Sep-04, to lugnet.robotics)
|
35 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
