| |
Kevin L. Clague wrote:
> Great job Mark! Isn't it great when those optimizations just hit you?
It sure is. Thanks.
Using the same pattern (setting up specific switches "backwards"), I can
do a half adder with two pistons and 4 switches (2 switches on each
piston). Again, no need for inter-piston bracing, just the requirement
that a piston simultaneously slide all the switches attached to it.
http://www.members.shaw.ca/markt1964/halfadder.jpg
>> Mark
|
|
Message has 1 Reply:
 | | Re: A better full adder!
|
| (...) Finally I can compete again! ;^) I can do a half adder with 1 piston and seven switches, plus you get dual polarity pressure. Three switches for AND and four for XOR. This says that I can do single pressure logic line with one piston and three (...) (21 years ago, 26-Jun-03, to lugnet.technic, lugnet.robotics)
|
Message is in Reply To:
27 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
