Subject:
|
Re: motorized points - finally got it!
|
Newsgroups:
|
lugnet.trains, lugnet.robotics
|
Date:
|
Mon, 4 Dec 2000 23:24:46 GMT
|
Viewed:
|
58 times
|
| |
|
|
Here's some pics on brickshelf. Sorry that they are blurry, the digi-cam I
have dosen't seem to do well at close range.
http://www.brickshelf.com/cgi-bin/gallery.cgi?f=2246
SteveB
PS No modifications where made on the switch!
In lugnet.trains, Steven Barile writes:
> Yippy I finally got it!
> I have created a motorized switch track that ran 100 switches via RCX
> without tearing the housing apart or miss firing! After 100 I got tired
> of counting and I just stopped it, so it might go for several hundred. It
> sits flush with the bottom of the points so no plate(s) are used below the
> track. The yellow throw arm was removed so the link is direct to the dark
> gray slider. It is very small and uses a small 8 toothed gear directly
> against a rack. The motor is the new motor with built in gear reduction. The
> motor is mounted such that the axel point straight down and the rack is on
> the side of a technic beam. The housing is pinned in two dimensions so
> things are held together very well.
> I programmed it with the stock RCX software. There is no feedback sensor
> used. The program is simple:
>
> power = 8
> on for .1 sec
> power = 4
> on for .1 sec
>
> I ran this in a loop with a "2 sec wait" and "motor reverse" statements.
>
> I'll post pics add building instructions in the next couple days.
>
> SteveB
> PNLTC
|
|
Message is in Reply To:
 | | Re: motorized points - finally got it!
|
| Yippy I finally got it! I have created a motorized switch track that ran 100 switches via RCX without tearing the housing apart or missing firing! After 100 I got tired of counting and I just stopped it, so it might go for several hundred. It sits (...) (24 years ago, 4-Dec-00, to lugnet.trains, lugnet.robotics)
|
22 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
