 | | Re: LinuxPPC and "No response from RCX" problem
|
|
(...) Did you set the correct permissions for the serial ports (normally they're only accessible by root under Linux) Do a chmod 777 for /dev/ttyS0 (26 years ago, 3-Nov-00, to lugnet.robotics.rcx.nqc)
|
| |
 | | LinuxPPC and "No response from RCX" problem
|
|
Hi, I recently bought an RIS kit and from my Windows box it works fine. When I try using LinuxPPC off my PPC Amiga I get the following: [root] /home/chris/nqc/nqc-2.2.r2 >bin/nqc -v -raw 10 Tx: 55 ff 00 10 ef 10 ef Rx: 55 ff 00 10 ef 10 ef Tx: 55 ff (...) (26 years ago, 3-Nov-00, to lugnet.robotics.rcx.nqc)
|
| |
 | | Re: How2 'count' in NQC
|
|
In lugnet.robotics, Jerry Kalpin writes: [SNIP] (...) There is an EDGE mode available through the firmware that only counts transitions between pressed and non-pressed (actually some raw threshold value if I remember correctly) states. This sensor (...) (26 years ago, 3-Nov-00, to lugnet.robotics)
|
| |
 | | Re: How2 'count' in NQC
|
|
I have noticed this ongoing thread about the difficulties of debouncing and counting switch closures, and I must say that it is a very real problem anywhere electromechanical switches are interfaced to electronics which is orders of magnitude (...) (26 years ago, 3-Nov-00, to lugnet.robotics)
|
| |
 | | Re: How2 'count' in NQC
|
|
Steve, this is the third time you have helped me, and this time you obviously spent a lot of time working out the alternatives. First of all, the Wait (DELAY); in my inept code was not to flash every half second. It was to prevent additional counts (...) (26 years ago, 3-Nov-00, to lugnet.robotics)
|
| |
 | | Re: Radio Controlled Tank - tread lightly.
|
|
(...) Yes, please! :) Have to check if they sell Funrise brand toys here in Sweden. //Harri Manni -"Do not take life too seriously.You will never get out alive." (26 years ago, 3-Nov-00, to lugnet.robotics)
|
| |
 | | Re: MOC: Radio Controlled Tank.
|
|
(...) Here's an idea you can try to have them slip a bit less. Do you have the ordinary chain links too? Then ones without the wide tread? If so use an ordinary chain link for every third link, say. Like this: ##=##=##=##= Perhaps this will give (...) (26 years ago, 3-Nov-00, to lugnet.technic, lugnet.robotics)
|
| |
 | | Re: MOC: Radio Controlled Tank.
|
|
(...) Thanks :) (...) Yes, they sure were. One of 'em I even managed to scare twice, first when the tank entered the room and then when it actually fired a projectile :) To bad it takes almost half a minute to set the cannon horisontally, I have to (...) (26 years ago, 3-Nov-00, to lugnet.technic, lugnet.robotics)
|
| |
 | | Re: MOC: Radio Controlled Tank.
|
|
(...) Thanks! So do I :) (...) It's from before my dark ages, mainly the 8851 Excavator and the 8660 Arctic Rescue, I also got two with the 8843 Fork Lift truck. They usually look better then they work since they tend to slip a lot, but in this case (...) (26 years ago, 3-Nov-00, to lugnet.technic, lugnet.robotics)
|
| |
 | | Re: Palm Hardware Interface idea? + other stuff
|
|
(...) It's basically the same serial data connection as the RCX. It just uses radio for transmission instead of infrared, so it goes around corners and has a longer range. Jürgen (26 years ago, 3-Nov-00, to lugnet.robotics)
|
| |
 | | Programmable RCX display
|
|
One of the missing "nice-to-have" features with the RCX is a programmable display. It would be great if LEGO implemented this feature. One way could be to attach a number 0 - 6 for each segment of the four 7-segment numbers and set a corresponding (...) (26 years ago, 3-Nov-00, to lugnet.robotics.rcx.nqc)
|
| |
 | | Re: RCX 2
|
|
(...) You can start by doing some searches on this newsgroup for the 3 or so discussions on this very topic. Dean -- Coin-Op's For Sale!: (URL) Lego Workshop: (URL) Lego Club: (URL) (26 years ago, 3-Nov-00, to lugnet.robotics)
|
| |
 | | Re: Still JAVA and LNP....
|
|
(...) There is no way to passively listen to the world. This is good for batteries but bad in all other ways. So, your listening code should send a keep-alive on a regular basis to keep the tower from dying. No way around it :| Luis ---...--- "It's (...) (26 years ago, 3-Nov-00, to lugnet.robotics.rcx.legos)
|
| |
 | | Re: How2 'count' in NQC
|
|
(...) The sensor returns 1 for as long as it's held down. In your code: (...) You are actually counting how long the switch is held down - in units of about a half second. So if you press and hold the switch for ten seconds, you'll get a count of (...) (26 years ago, 3-Nov-00, to lugnet.robotics)
|
| |
 | | Re: RCX2
|
|
(...) Right now, it's just a different firmware package that you can download into any RCX. You can get a copy on the main Lego site and upgrade your RCX 1.0 or 1.5 to the 2.0 software level...it's a significant improvement if you use NQC - it adds (...) (26 years ago, 3-Nov-00, to lugnet.robotics)
|
| |
 | | Re: Motor Sticking
|
|
(...) I have about 16 motors and I have had, out of the box, 6 motors DOA... Other friends have more then 20 motors with 0 failures... I can only guess that I'm cursed with motors. S@H will replace ALL your dead motors... They did for me. Once when (...) (26 years ago, 3-Nov-00, to lugnet.robotics.rcx, lugnet.technic)
|
| |
 | | RCX 2
|
|
Hi, heh... and what is RCX2 ? Where can I find some infos about differences between RCX and RCX2 ? Thanx. Norbi (26 years ago, 3-Nov-00, to lugnet.robotics)
|
| |
 | | Re: Still JAVA and LNP....
|
|
Umm in response to my own message, would someone be so kind as to explain the following <g> : // return (short)(a + (b << 8)); return (short)(a % 256); If I use the bottom line, discounting variable b, then my checksum is correct...otherwise it (...) (26 years ago, 3-Nov-00, to lugnet.robotics.rcx.legos)
|
| |
 | | Re: MOC: Radio Controlled Tank.
|
|
(...) Wow...this creation looks awesome. Great work! (...) Heheh...That seems like it would be really neat...they must have been quite surprised :-) As a side note, does anyone know how one can get extra polarity switches? They appear in some older (...) (26 years ago, 3-Nov-00, to lugnet.technic, lugnet.robotics)
|
| |
 | | Still JAVA and LNP....
|
|
hey all :) Sorry to bother again, but after limited uccess with getting JAVA to cope with LNP, I've run into some (hopefully) simple problems, I'm having major problems with the checksum routine, this routine give me huge integer nnumbers rather (...) (26 years ago, 3-Nov-00, to lugnet.robotics.rcx.legos)
|