 | | 'Antarctica' MindStorm Challenge in Singapore
|
|
Check this out! =) 167 (~10 students each) teams from 32 primary and 47 secondary schools are taking part in Singapore's first National Junior Robotics Challenge. They have 3 months to design, build and test-run their robots. The teams must use only (...) (27 years ago, 10-Jul-99, to lugnet.robotics)
|
| |
 | | Am I missing something? (was: Re: Have 4 motors, need help!)
|
|
From: Bob Fay <rfay@we.mediaone.net> (...) leaves three outputs for the other three motors. Not really a special solution. Isn't the problem really "how do I make the three outputs drive more than three motors (or whatever), each in an independent (...) (27 years ago, 10-Jul-99, to lugnet.robotics)
|
| |
 | | Re: motors
|
|
Hi, I found that one of my Mindstorms motors is a bit stronger than the other. The robot should go forward, but slightly diverts right. When I exchange the motors and nothing else, it diverts to the left. Does anybody else have similar experiece? (...) (27 years ago, 10-Jul-99, to lugnet.robotics)
|
| |
 | | Light source location
|
|
I've just started playing with RIS (last time I had lego was 20 years ago!) and I was trying to figure out if, using the lego programming language, you could locate the strongest light source. I.e rotate, record all levels and then locate the (...) (27 years ago, 10-Jul-99, to lugnet.robotics)
|
| |
 | | RE: RIS vs Rug Warriors
|
|
I've never heard of rug warriors, is this something new that Lego offers? I'm a robot freak, so anything I can add to the repertoire of relatively low cost "toys" is a godsend (It's a VERY expensive hobby, not to mention Lego's aren't all that cheap (...) (27 years ago, 5-Jul-99, to lugnet.robotics)
|
| |
 | | Re: Light source location
|
|
(...) Yes. The lego software does not support variables or math, so forget trying to remember anything or figure out how you got there! NQC is definitely the way to go. (27 years ago, 12-Jul-99, to lugnet.robotics)
|
| |
 | | With what to Begin?
|
|
Hello Mindstormers, as a total newbie to all this, I am looking for some very basic info: I am currently contemplating to buy my very first Mindstorm set, and would like to find some advice about what makes a good starting combination (considering (...) (27 years ago, 12-Jul-99, to lugnet.robotics)
|
| |
 | | Re: With what to Begin?
|
|
In my humble opinion, I wouldn't touch those expansion packs with a 10 foot pole. I have both and when I got them, there was little to no docs on them. I figured I would be getting a Sensor in each. I would say for the 54.00+tax that the expansions (...) (27 years ago, 12-Jul-99, to lugnet.robotics)
|
| |
 | | Re: motors
|
|
(...) Unfortunately, almost all of the motors are slightly uneven. Look up "adder/subtracter" or go back through the list to find mechanical solutions which allow your robot to go in a straight line regardless. The archives are at (...) (27 years ago, 12-Jul-99, to lugnet.robotics)
|
| |
 | | Re: 256 Colours
|
|
(...) For that matter, so will just leaving Win98 running doing nothing :). Don't you just love Microsloth? John A. Tamplin Traveller Information Services jat@LiveOnTheNet.COM 2104 West Ferry Way 256/705-7007 - FAX 256/705-7100 Huntsville, AL 35801 (...) (27 years ago, 12-Jul-99, to lugnet.robotics)
|
| |
 | | Re: What is LEGO Dacta eLAB?
|
|
Todd Lehman wrote: <snip> I noticed in the rcx section they mentioned a sensor adaptor that could be used with other manufacturers' sensors. This might mean that Lego have realized the need for more, cheaper sensors at last :) -- Thomas Main (...) (27 years ago, 12-Jul-99, to lugnet.general, lugnet.robotics)
|
| |
 | | Re: Am I missing something? (was: Re: Have 4 motors, need help!)
|
|
(...) Is there such a hardware/construction FAQ anywhere? I know there was an attempt at such a thing quite some time ago by the lugnet folks, but I have no idea if that ever got off the ground or not. I don't really have time to work on one right (...) (27 years ago, 12-Jul-99, to lugnet.robotics)
|
| |
 | | Problem with accessing analog and digital ports on HB with IC2.81
|
|
Hello, (newbie warning - I've read the FAQ and manuals, but I may still be missing something very trivial. Still, thanks for making it so far!) I just bought a handyboard from Gleason Research (with the expansion board) and started going through the (...) (27 years ago, 12-Jul-99, to lugnet.robotics.handyboard)
|
| |
 | | Re: VERY [OT] Feathers 'n Lead...
|
|
(...) I think the original poster was putting his tongue firmly in cheek there. BTW, the dropping of objects would be a second experimental proof that gravity affects all objects equally regardless of weight. Best test being in a vacuum where you (...) (27 years ago, 12-Jul-99, to lugnet.robotics.rcx)
|
| |
 | | Re: motors
|
|
(...) Out of the 6 motors that I own none of them rotate at the same speed. (URL) has some mechanical solutions (using an adder/subtractor) for solving this problem. Note that for many types of robots (line followers, etc) it really isn't a problem, (...) (27 years ago, 12-Jul-99, to lugnet.robotics)
|
| |
 | | RE: VERY [OT] Feathers 'n Lead...
|
|
(...) Sorry for the extra quoting here, but the thread was a bit old...and just for everyone's info, both bags have the SAME mass, so they have the same first moment of inertia....I think. The shape of the object generally affects the SECOND momemnt (...) (27 years ago, 12-Jul-99, to lugnet.robotics.rcx)
|
| |
 | | Re: Have 4 motors, need help!
|
|
(...) Yes, that is where I saw it. It was when I visited that site to download the NQC Command Center, which I have found very useful. (...) again (...) of (...) (27 years ago, 12-Jul-99, to lugnet.robotics)
|
| |
 | | Re: Help with 9738 LEGO Mindstorms Remote Control
|
|
Dave's reply is right on the mark, but I also want to point out that if you have downloaded a non-MindStorms O.S. to the RCX (i.e. any firmware other than the standard LEGO MindStorms firmware) the remote might not work either. I haven't tried any (...) (27 years ago, 12-Jul-99, to lugnet.robotics.rcx)
|
| |
 | | Re: Subsumption Architecture
|
|
(...) Nick, I used Handy Boards in my AI class last year and have several labs available on the web. Check out the link: (URL) look at the "Lab 3" link for some starter code on subsumption architecture. Lisa (27 years ago, 12-Jul-99, to lugnet.robotics.handyboard)
|
| |
 | | Re: Lego Solar Cell Specs
|
|
Alan Carmack wrote in message ... (...) one (...) Do you happen to know the detailed specifications of the Edmunds Scientific panels? I ask because you need to know both the voltage and the current that will be supplied by the solar panel under (...) (27 years ago, 12-Jul-99, to lugnet.robotics)
|