To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.org.ca.rtltorontoOpen lugnet.org.ca.rtltoronto in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Organizations / Canada / rtlToronto / 7882
7881  |  7883
Subject: 
Re: DCC party?
Newsgroups: 
lugnet.org.ca.rtltoronto
Date: 
Mon, 7 Jul 2003 16:36:07 GMT
Viewed: 
559 times
  
In lugnet.org.ca.rtltoronto, Derek Raycraft wrote:
Are we going DCC for NMRA?

I'm willing to convert two of my train motors to DCC if we are going to
do DCC for NMRA.  I will however need help making the conversion.  I've
done a little soldering but I'm not super comfortable with electronics.
Assistance would be appreciated.

We should also design a building for the the DCC RCX to hide in.
Something that hides the RCX but allows the IR port to be visible from
around the layout.  A small tower in one corner could work.

I'm also planing to destroy a few straight pieces of track in an attempt
to make a 45degree crossing.  If it works it will be really cool for
driving DCC trains all around the layout.  If it doesn't then I'll have
a few messed up straight pieces.  :-)

Derek

ps. How's the new car Calum?

I'm all set for DCC

I've downloaded the boosters and such from Mark's page and have tested 'em, but
I only have 1 AC capable RCX.  I think we'll need at least 3 for the layout--1
for each loop. We'll also need the 5 cm gap pieces to separate the segments, of
which I have 2.  We could go with the tape idea--is a good idea.

Dave K



Message has 1 Reply:
  Re: DCC party?
 
(URL) do the RCX + booster RCX's, we need one RCX with the IR port exposed to a wide an angle as possible to pick up the IR remote signals. THe other RCX's can be completely embedded into the layout--they need a track wire coming from the primary (...) (21 years ago, 7-Jul-03, to lugnet.org.ca.rtltoronto)

Message is in Reply To:
  DCC party?
 
Are we going DCC for NMRA? I'm willing to convert two of my train motors to DCC if we are going to do DCC for NMRA. I will however need help making the conversion. I've done a little soldering but I'm not super comfortable with electronics. (...) (21 years ago, 7-Jul-03, to lugnet.org.ca.rtltoronto)

17 Messages in This Thread:






Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR