| |
> HI Garry,
>
> Thanks a lot for the release of this utility so quick.
> I do have an other question:
> Can you, when possible, in one of the next releases, make it possible to
> enter the label dimensions in imperial or metric system in the LABEL • DESIGN
> form(using a selection button)?
Yes, I do intend to support dimensions in alternate measurement units.
-Gary
|
|
Message is in Reply To:
 | | Re: Lego Part Label Printer
|
| (...) HI Garry, Thanks a lot for the release of this utility so quick. I do have an other question: Can you, when possible, in one of the next releases, make it possible to enter the label dimensions in imperial or metric system in the LABEL DESIGN (...) (23 years ago, 20-Aug-01, to lugnet.general, lugnet.storage)
|
34 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
