| |
In lugnet.cad.dev, Lars C. Hassing wrote:
> [1] I have been thinking about suggesting a property "0 FILETYPE PART"
> to enable seams for parts in an MPD...
> ("0 FILETYPE PRIMITIVE" doesn't seem to have any use for the moment)
Try looking for lines with the following:
0 [Official|Unofficial] ... [Part|Element|Primitive|Subpart|Model]
I admit, the "Official/Unofficial" flag is kludgy, but I was working with
what I had...
Another MPD suggestion: 0 FILEEND. This would allow nested MPDs,
especially MPDs compiled from multiple sources.
Steve
|
|
Message is in Reply To:
 | | Re: tubing
|
| Larry Pieniazek wrote... (...) My "fake" seams seem to be the problem ;-) As you can see on (URL) scale parts a little bit to make a seam between parts. ("parts" are here DAT files found in the PARTS directory [1]) Normally this works fine, because (...) (26 years ago, 3-Oct-00, to lugnet.cad.dev, lugnet.cad.mlcad)
|
20 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
