LEGO Digital Designer : 221


CAD / LDD / 221	220 \| 222

Subject:	Re: Can anyone get these parts to intersect at right angles in LDD?
Newsgroups:	lugnet.cad.ldd
Date:	Wed, 17 Jun 2009 11:59:24 GMT
Viewed:	26746 times

> I've been trying ever since the larger Z20 double conical wheel was > available through the Factory palette in LDD, however, I've had no luck at > all getting them intersecting each other at right angles. Same thing here. I was able to mesh Z36 with Z12 and "almost" z36 with z20. All other combinations that obviously works fine in real world failed. Philo

Message has 1 Reply:

		Re: Can anyone get these parts to intersect at right angles in LDD?
"Philippe Hurbain" <philohome@free.fr> wrote in message news:KLDtB0.Bv7@lugnet.com... (...) From what I and a lurker here figured out in a few emails to each other, it would appear that the problem is that LDD's collision engine is a bit (...) (15 years ago, 17-Jun-09, to lugnet.cad.ldd)

Message is in Reply To:

		Can anyone get these parts to intersect at right angles in LDD?
To TLG: I have found that there is a problem with the two gears, which LDD refers to as "double conical wheel", included in LEGO Factory. These are described in the LDD Factory palette as "double conical wheel Z12 1M" and "double conical wheel Z20 (...) (15 years ago, 17-Jun-09, to lugnet.cad.ldd)

11 Messages in This Thread:

Entire Thread on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact
This Message and its Replies on One Page:: Nested: All | Brief | Compact | Dots
Linear: All | Brief | Compact

Custom Search