Subject:
|
Re: Help with Patterns
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Sat, 23 Aug 2008 18:21:55 GMT
|
Viewed:
|
20027 times
|
| |
|
|
In lugnet.cad.dat.parts, Michael Heidemann wrote:
> In lugnet.cad.dat.parts, Benjamin Lyttle wrote:
> > I've been working on the pattern for 3069bpx28 "Tile 1 x 2 with Blue Screen and
> > Red and Silver Panel Pattern" I'm having trouble stacking the different colors
> > on each other, the main color bleeds through the other ones even when I've made
> > 3 subpart files to stack different colors. I've looked at other patterns and
> > can't see that I've done anything differently. Any suggestions?
>
> You should not "stack" the colors. Each color is only in one area. For example
> if you have a red ring around a yellow disc you have to model the yellow disc
> and a red ring around it and not stack a red disc over the yellow ring. All
> surfaces of a pattern is in the same plane!
>
> cu
> mikeheide
That helps - it is also what I was afraid of - trying to fill in little gaps at
weird angles.
Thanks, back to the pasting board,
ben
|
|
Message has 1 Reply:
 | | Re: Help with Patterns
|
| (...) If you didn't use it, have a look to Quad2dat ((URL) this may help a lot! And to reimport what you already did, you may use Dat2qp: (URL) (18 years ago, 23-Aug-08, to lugnet.cad.dat.parts)
|
Message is in Reply To:
| | Re: Help with Patterns
|
| (...) You should not "stack" the colors. Each color is only in one area. For example if you have a red ring around a yellow disc you have to model the yellow disc and a red ring around it and not stack a red disc over the yellow ring. All surfaces (...) (18 years ago, 23-Aug-08, to lugnet.cad.dat.parts)
|
18 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
