Subject:
|
Re: Help with Patterns
|
Newsgroups:
|
lugnet.cad.dat.parts
|
Date:
|
Sat, 23 Aug 2008 17:22:34 GMT
|
Viewed:
|
9947 times
|
| |
|
|
In lugnet.cad.dat.parts, Benjamin Lyttle wrote:
> I've been working on the pattern for 3069bpx28 "Tile 1 x 2 with Blue Screen and
> Red and Silver Panel Pattern" I'm having trouble stacking the different colors
> on each other, the main color bleeds through the other ones even when I've made
> 3 subpart files to stack different colors. I've looked at other patterns and
> can't see that I've done anything differently. Any suggestions?
You should not "stack" the colors. Each color is only in one area. For example
if you have a red ring around a yellow disc you have to model the yellow disc
and a red ring around it and not stack a red disc over the yellow ring. All
surfaces of a pattern is in the same plane!
cu
mikeheide
|
|
Message has 1 Reply:
 | | Re: Help with Patterns
|
| (...) That helps - it is also what I was afraid of - trying to fill in little gaps at weird angles. Thanks, back to the pasting board, ben (16 years ago, 23-Aug-08, to lugnet.cad.dat.parts)
|
Message is in Reply To:
| | Help with Patterns [DAT]
|
| I've been working on the pattern for 3069bpx28 "Tile 1 x 2 with Blue Screen and Red and Silver Panel Pattern" I'm having trouble stacking the different colors on each other, the main color bleeds through the other ones even when I've made 3 subpart (...) (16 years ago, 23-Aug-08, to lugnet.cad.dat.parts)
|
18 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
