Subject:
|
Re: Error in 71427.dat
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Sun, 10 Jan 1999 06:32:10 GMT
|
Viewed:
|
1497 times
|
| |
|
|
On Sun, 10 Jan 1999 03:20:31 GMT, "John VanZwieten"
<john_vanzwieten@msn.com> wrote:
I get errors like this all the time in the new parts. I had to make
it a habit of visually scanning each part file submitted to me just
for that reason.
I am sure that it is not the authors fault. Long lines have a
tendency to get wrapped in various ways.
I remember I always had a real hard time with Tom Burger's parts -
somehow, his system and mine always seemed to conflict. Just about
every part he would send me would get mangled. And since his piece
code looked virtually the same as anyone else's, I just assumed that
something between he and I was screwing it up.
-- Terry K --
> I'm wondering just where this error was introduced, as it is not in the
> original file. It's likely related to line length restrictions, either on
> my outgoing e-mail, Lugnet, or our incoming e-mail.
>
> I did notice a couple of missing type 2 lines, though, which will be
> corrected for the official vote.
>
> -John Van
>
> John Bauman wrote in message ...
> > umm there is a number 40 on the third line from the last on John's
> > VanZwieten's motor.It should be cut and appended to the line above it.
|
|
Message has 2 Replies:
 | | Re: Error in 71427.dat
|
| Terry K wrote in message <369847b6.1503620@lu...et.com>... (...) Just run the file through l3p.It tells you where the errors are (...) (26 years ago, 10-Jan-99, to lugnet.cad)
| | | Re: Error in 71427.dat
|
| (...) I'm probably as big an offender as anyone. Something part-authors should do (besides running their files through LDLite -G and L3P before submitting them) is to either turn off line-wrapping in their e-mail program when sending Terry parts, or (...) (26 years ago, 11-Jan-99, to lugnet.cad)
|
Message is in Reply To:
| | Re: Error in 71427.dat
|
| I'm wondering just where this error was introduced, as it is not in the original file. It's likely related to line length restrictions, either on my outgoing e-mail, Lugnet, or our incoming e-mail. I did notice a couple of missing type 2 lines, (...) (26 years ago, 10-Jan-99, to lugnet.cad)
|
14 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
