Subject:
|
Re: Error in 71427.dat
|
Newsgroups:
|
lugnet.cad
|
Date:
|
Sun, 10 Jan 1999 03:20:31 GMT
|
Viewed:
|
1269 times
|
| |
|
|
I'm wondering just where this error was introduced, as it is not in the
original file. It's likely related to line length restrictions, either on
my outgoing e-mail, Lugnet, or our incoming e-mail.
I did notice a couple of missing type 2 lines, though, which will be
corrected for the official vote.
-John Van
John Bauman wrote in message ...
> umm there is a number 40 on the third line from the last on John's
> VanZwieten's motor.It should be cut and appended to the line above it.
>
>
>
>
|
|
Message has 1 Reply:
 | | Re: Error in 71427.dat
|
| On Sun, 10 Jan 1999 03:20:31 GMT, "John VanZwieten" <john_vanzwieten@msn.com> wrote: I get errors like this all the time in the new parts. I had to make it a habit of visually scanning each part file submitted to me just for that reason. I am sure (...) (26 years ago, 10-Jan-99, to lugnet.cad)
|
Message is in Reply To:
| | Error in 71427.dat
|
| umm there is a number 40 on the third line from the last on John's VanZwieten's motor.It should be cut and appended to the line above it. (26 years ago, 10-Jan-99, to lugnet.cad)
|
14 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
