Subject:
|
Re: wishin' on a star
|
Newsgroups:
|
lugnet.build
|
Date:
|
Wed, 7 Jul 2004 18:25:26 GMT
|
Viewed:
|
946 times
|
| |
|
|
In lugnet.build, Deborah Higdon wrote:
| |
In lugnet.dear-lego, Larry Pieniazek wrote:
|
| |
| |
Those are some awesome parts all right. Many of us wish for some of the
corner slope stuff you generated. Nice LDraw modeling (or however you did
it... how DID you do it?)!
|
thanks! i used mlcad to put one, two or more pieces together, took a jpg
photo then went into photo-paint to doctor it up.
|
As I suspected. Your surgery worked!
| |
| |
One question, I dind’t quite follow
17 though. Can you
talk a bit more about that one? How’s it differ from the
bell jar part? What’s it
supposed to do? Can you “use it in a sentence?” ;-)
|
it’s the smaller version of the bell jar but it has no centre stud, therefore
when used upside down, has a lovely hole that could be a sink, ... a toilet
bowl ... the sky’s the limit!
|
Ah, OK. So is it only 1 stud around or is it a 2x2?
The view you chose didn’t make that clear. For a couple of these parts showing
them in use with another part, or showing several angles, might clarify the
usages.
Most of them (the new and different kinds of tiles) are quite clear with just
the view you chose, though
|
|
Message has 2 Replies:
 | | Re: wishin' on a star
|
| (...) it's a 2x2x2. (...) unfortunately, i'm flying by the seat of my pants here. while i figured out how to go from mlcad drawing to jpg to photo-paint, i haven't figured out the reverse process. now that i've got a new piece, how do i get it back (...) (20 years ago, 7-Jul-04, to lugnet.build, FTX)
| | | Re: wishin' on a star
|
| (...) The stud notches pretty much peg it as a 2x2. (...) I was able to figure them all out without any trouble, with only a few exceptions: 1. Double-ended clip plate (not sure why the other two variants weren't included). 4. 1x1 round tile. 6. (...) (20 years ago, 7-Jul-04, to lugnet.build, FTX)
|
Message is in Reply To:
| | Re: wishin' on a star
|
| (...) thanks! i used mlcad to put one, two or more pieces together, took a jpg photo then went into photo-paint to doctor it up. (...) it's the smaller version of the bell jar but it has no centre stud, therefore when used upside down, has a lovely (...) (20 years ago, 7-Jul-04, to lugnet.build, FTX)
|
15 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
