Subject:
|
Re: Coal Process Plant
|
Newsgroups:
|
lugnet.trains
|
Date:
|
Sat, 4 Dec 1999 17:40:10 GMT
|
Viewed:
|
1023 times
|
| |
|
|
Ed McGlynn wrote in message ...
> In lugnet.trains, Larry Pieniazek writes:
> > Ed McGlynn wrote:
> >
> > > I'm curious on how you managed the black crossbream effect on the front • of
> the
> > I'm betting 2finger/3finger 1x2 plate hinges. One cross brace seems in
> > front of the other.
> >
> > The way I did the GMLTC coaling station uses those bracing rods (in red
> > in the newer shuttle pad) for this.
>
> Thanks for the insight, Larry.
> Mind mind is definitely drifting toward the same bracing rods you speak of,
> but in black, as from the Outback Airstrip. I think the super low slope • roof
> bricks from that set would add a nice dark grey component to such a coal
> processing structure.
I think Larry was referring to the technic cross axles with rings at each
end for a technic pin from 6339.
Frank
|
|
Message has 1 Reply:
 | | Re: Coal Process Plant
|
| (...) Yes. Conan has a bunch of those in grey from somewhere so I used them both in the water tower and the coaling tower. I DID use the 2x2x5 lattice columns in my sanding tower. from Paul Foster's page of pics: (URL) one shows my coaling tower (on (...) (25 years ago, 5-Dec-99, to lugnet.trains)
|
Message is in Reply To:
| | Re: Coal Process Plant
|
| (...) the (...) Thanks for the insight, Larry. Mind mind is definitely drifting toward the same bracing rods you speak of, but in black, as from the Outback Airstrip. I think the super low slope roof bricks from that set would add a nice dark grey (...) (25 years ago, 4-Dec-99, to lugnet.trains)
|
13 Messages in This Thread:
 
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
