Subject:
|
Re: Coal Process Plant
|
Newsgroups:
|
lugnet.trains
|
Date:
|
Sat, 4 Dec 1999 14:28:36 GMT
|
Viewed:
|
936 times
|
| |
|
|
In lugnet.trains, Larry Pieniazek writes:
> Ed McGlynn wrote:
>
> > I'm curious on how you managed the black crossbream effect on the front of • the
> I'm betting 2finger/3finger 1x2 plate hinges. One cross brace seems in
> front of the other.
>
> The way I did the GMLTC coaling station uses those bracing rods (in red
> in the newer shuttle pad) for this.
Thanks for the insight, Larry.
Mind mind is definitely drifting toward the same bracing rods you speak of,
but in black, as from the Outback Airstrip. I think the super low slope roof
bricks from that set would add a nice dark grey component to such a coal
processing structure.
Ed
|
|
Message has 1 Reply:
 | | Re: Coal Process Plant
|
| Ed McGlynn wrote in message ... (...) of (...) roof (...) I think Larry was referring to the technic cross axles with rings at each end for a technic pin from 6339. Frank (25 years ago, 4-Dec-99, to lugnet.trains)
|
Message is in Reply To:
| | Re: Coal Process Plant
|
| (...) I'm betting 2finger/3finger 1x2 plate hinges. One cross brace seems in front of the other. The way I did the GMLTC coaling station uses those bracing rods (in red in the newer shuttle pad) for this. (25 years ago, 4-Dec-99, to lugnet.trains)
|
13 Messages in This Thread:
 
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
