Subject:
|
Re: Custom Curved Switch in our layout
|
Newsgroups:
|
lugnet.trains
|
Date:
|
Tue, 6 Apr 2004 16:20:32 GMT
|
Viewed:
|
1625 times
|
| |
| |
Mark Riley wrote:
> In lugnet.trains, David Koudys wrote:
> > As promised--
> >
> > http://sparky.i989.net/ltrain.htm
> >
> > Wow was that fun. I woldn't want to do it everyday, but for the cost of 2 curve
> > track pieces and 1 switch, it wasn't so bad...
>
> Great mods, Dave! I can just imagine the wonderful smell of all that freshly
> sawed ABS permeating your basement... :-)
>
> I had a question: I've nevered worked with hot glue before, how well would you
> say it grips the ABS?
>
> Thanks,
>
> Mark
I have not tried the hot melt glue, myself, but use 3M Super Strength
Adhesive... containing MEK. I like the result; strong, not brittle;
just a bit rubbery. For the reinforcement, I use plastic coated wire.
The glue bonds well to the coating, then the wire provides good strength.
I am not sure which smell I dislike the most: cut/hot plastic or the
glue. :)
// Joe
p.s. If there is enough interest, I would be happy to list a couple
pairs on BL.
|
|
Message has 1 Reply: | | Re: Custom Curved Switch in our layout
|
| (...) You and I had talked about a side transaction regarding these (I have a pair of Jeff C's crossovers already). Listing them on BL may be a lot less hassle from a tracking/collecting perspective so I think you should! (21 years ago, 6-Apr-04, to lugnet.trains)
|
Message is in Reply To:
| | Re: Custom Curved Switch in our layout
|
| (...) Great mods, Dave! I can just imagine the wonderful smell of all that freshly sawed ABS permeating your basement... :-) I had a question: I've nevered worked with hot glue before, how well would you say it grips the ABS? Thanks, Mark (21 years ago, 6-Apr-04, to lugnet.trains)
|
16 Messages in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|