To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.trainsOpen lugnet.trains in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Trains / 20182
20181  |  20183
Subject: 
Re: DCC for the RCX
Newsgroups: 
lugnet.robotics.rcx, lugnet.trains
Date: 
Thu, 29 May 2003 03:43:12 GMT
Viewed: 
337 times
  
When I installed my first decoders (Digitrax DN121), I omitted
the capacitors, figuring if the buzzing was annoying, I could always
add them later.  As it turns out, there is a little buzzing at low
speeds, but it is not annoying to me (YMMV).  In fact, for my
diesels, it sounds like a low grumbling which reminds me of the low
"thrumming" you get as the prototype leaves the yard.  I just
installed a DZ143, and it buzzes at about half the volume of the
DN121s.


I don't install them either, and I have done something like 30 motors so far.

If you are referring to Tom's L-Gauge page, the resistor is
used for the headlight to lower the ~12V DCC voltage to 9V
for use with a standard Lego lamp brick.  I didn't need to
use this resistor since the RCX is already putting out about
9V.


True, but ONLY if you are just going to use the RCX as a output.  You can dial
the voltage that DB100's (and most other Digitrax) boosters put out to a exact
voltage as well, however it is something I haven't worried about yet.  For the
most part, this does limit the range of useable speed with a unprogrammed
decoder to the lower 1/2 of the scale.

I did however, add a diode in parallel with the lamp output
in case I decide to run an inductive load such as a
relay or motor on the lamp output.

I have gotten away with the lego motors so far.  However, YMMV :)  and no, I
don't put diodes on them.

James P



Message has 1 Reply:
  Re: DCC for the RCX
 
(...) I'm no electronics engineer by any stretch-- A diode, iirc, allows DC current to 'flow thru' in only one direction. What would a diode do across the output on the top of the train motor? And why would one be good for 'inductive' loads such as (...) (21 years ago, 29-May-03, to lugnet.robotics.rcx, lugnet.trains)

Message is in Reply To:
  Re: DCC for the RCX
 
(...) I (...) resistors (...) goes (...) run (...) the (...) isn't (...) reduce the (...) David, When I installed my first decoders (Digitrax DN121), I omitted the capacitors, figuring if the buzzing was annoying, I could always add them later. As (...) (21 years ago, 28-May-03, to lugnet.robotics.rcx, lugnet.trains)

35 Messages in This Thread:










Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR