 | | Re: Toy vs Model...The real issue (was Re: Another 6wide/8wide ramble)
|
|
John Neal <johnneal@uswest.net> wrote in message news:38B70743.BC3916...est.net... (...) layout (...) have (...) are (...) your (...) wide) (...) inter- (...) growing;) (...) I think that a more accurate measurement of size would be running feet of (...) (25 years ago, 26-Feb-00, to lugnet.trains)
|
| |
| | Re: Is this true?
|
|
(...) I see your a Straight Dope fan too. (URL) - Barbara (25 years ago, 26-Feb-00, to lugnet.trains)
|
| |
| | Re: My EMD SD40-2
|
|
(...) Who says the word snot is bad? Just watch Earthworm Jim! :-, Some of the maligned parts, such as BURPs, have found some very good uses as well. But they still keep the derogatory name. A piece is only useless or overspecialized until someone (...) (25 years ago, 25-Feb-00, to lugnet.trains, lugnet.build)
|
| |
| | Re: Toy vs Model...The real issue (was Re: Another 6wide/8wide ramble)
|
|
(...) Unless, of course, your layout is 22' long like the GMLTC's is (and growing;) (...) Not true. I rabbit sleep time;-) -John (...) (25 years ago, 25-Feb-00, to lugnet.trains)
|
| |
| | Re: Searchlight car
|
|
I'd go with B currently. Someday I hope TLC comes up with a way to pick up power that is separate from the motor. Power and propulsion should be separate... (...) (25 years ago, 25-Feb-00, to lugnet.trains)
|
| |
| | Re: Searchlight car
|
|
(...) One word: Wrecks. Two words: Construction Sites. Frank probably beat me to it as I've been moving all day... think about when and where you need light, and why you might not have it, and the need for a searchlight car becomes apparent. Now, (...) (25 years ago, 25-Feb-00, to lugnet.trains)
|
| |
| | Re: My EMD SD40-2
|
|
I think that SNOT is a malformed acronym then... We have been using derogatory acronyms to exemplify parts that we dislike because they aren't true to the spirit of Lego. Now, I would say a part like the 1x1 with side stud, or a part like the (...) (25 years ago, 25-Feb-00, to lugnet.trains, lugnet.build)
|
| |
| | Re: Searchlight car
|
|
Here is a thought: The spotlight could not rotate 360 degrees. There would not be any way for the internal light to receive constant power without the wires getting tangled (using pure methods anyhow.). To power the light you must use a wire to (...) (25 years ago, 25-Feb-00, to lugnet.trains)
|
| |
| | Re: Is this true?
|
|
(...) brought (...) Thanks for that James, it's a literal translation which is about as accurate as the general French opinion of British Beef. Jon (25 years ago, 25-Feb-00, to lugnet.trains)
|
| |
| | Re: Is this true?
|
|
(...) Otherwise known as a 2 CV :), oh, btw, they are _not_ two horsepower, since a Cheveaux is more than one horsepower...another mecanical oddity for you brought to you by the French... James P (25 years ago, 25-Feb-00, to lugnet.trains)
|
| |
| | Re: Toy vs Model...The real issue (was Re: Another 6wide/8wide ramble)
|
|
(...) By the same token, An 8-wide tarin layout in the same area as a 6-wide layout will (from a distance) look MORE toy-like simply because the trains will have a shorter run before 'chasing their tails'. Or, put another way, if you are into (...) (25 years ago, 25-Feb-00, to lugnet.trains)
|
| |
| | Re: Is this true?
|
|
There is a more basic theory.. The 4'8 1/2" is measured to the inside edges of the rails. When the original railways were pioneered in Britain using horse/gravity power and correspondingly lighter section rail (40lb/foot) there is evidence to (...) (25 years ago, 25-Feb-00, to lugnet.trains)
|
| |
| | Re: Searchlight car
|
|
Or you could use what they did with the new snow plow set and make it mechanically powered. If only there was a good way to do this with bogie cars... Anyone have ideas? Ben F (...) searchlight (...) it (...) plain (...) (25 years ago, 25-Feb-00, to lugnet.trains)
|
| |
| | Is this true?
|
|
Hi all, I copied the following from an email sent to me by a freind, can anyone confirm or flame it? The U.S. standard railroad gauge (distance between the rails) is 4 feet 8.5 inches. That's an exceedingly odd number. Why was that gauge used? (...) (25 years ago, 25-Feb-00, to lugnet.trains)
|
| |
| | Re: Searchlight car
|
|
I personally would use a motor on that car to feed it up to the light/motor. If I build this, I'll probably make it a generic light car, with the searchlight in the middle, and banks of floodlights on each end. If you look at the pic, it looks like (...) (25 years ago, 25-Feb-00, to lugnet.trains)
|
| |
| | Re: Searchlight car
|
|
Here's another question, maybe directed more at Tom S. but any experienced train(ee) will probably have their own method. I am mostly interested in techniques. To supply the light car with power would you a) build a 9V battery box into the generator (...) (25 years ago, 25-Feb-00, to lugnet.trains)
|
| |
| | Re: Searchlight car
|
|
(...) I'm sure Larry will have an answer as to whether searchlight cars were ever used in reality. It seems unlikely, but it certainly is a cool addition to a toy train. Actually, I'm sure there are various MOW cars with large lights. There is (...) (25 years ago, 25-Feb-00, to lugnet.trains)
|
| |
| | Re: Searchlight car
|
|
Forgive my ignorance on this one, What is it for? I understand it could be a simple freight item but from what I believe it is to be used as a working light. Why would you want a working search light in the middle of you train? -Nick Tom Stangl (...) (25 years ago, 25-Feb-00, to lugnet.trains)
|
| |
| | Searchlight car
|
|
Interesting car, I'll probably build one for my freight train, since it will be so simple to do... (URL) fun part will be adding a real light and micromotor to it, so it spins as the train moves. -- | Tom Stangl, Technical Support Netscape (...) (25 years ago, 25-Feb-00, to lugnet.trains)
|
| |
| | Re: My EMD SD40-2
|
|
(...) Word. Long live tiles;-) -John (...) (25 years ago, 25-Feb-00, to lugnet.trains)
|
