| | Train Tables, and my Round House
|
|
Well, I finally had a few rainy days to try to finish building my LEGO Train Tables (following Ben's original design). ftp://jeffk.com/pub/...lding.html I started to put my Round House onto the table, and remembered that I'd want to imbed the (...) (26 years ago, 1-Dec-98, to lugnet.trains)
|
|
| | 4552 to be Discontinued?
|
|
Are train sets discontinued as frequently as other system sets? I'm interested in #4552 Cargo Crane (available from S@H only), but I'm over my LEGO budget for quite a ways into next year. Should I borrow? DJ Zorn (26 years ago, 1-Dec-98, to lugnet.trains)
|
|
| | Re: sticker shock
|
|
On Sun, 29 Nov 1998 20:06:05 GMT, "Ben Fleskes" <benfleskes@msn.com> wrote: :Fully agreed. I see this all the time at the train shows PNLTC goes to. :People spending small fortunes to buy an engine or a car simply to run it :around a track. Well I (...) (26 years ago, 30-Nov-98, to lugnet.trains)
|
|
| | Re: 9V Speed Regulators
|
|
Jasper Janssen writes: >I stopped Lego before 9V trains came out - Does this mean LEgo 9V uses (...) No they aren't PWM, they vary the voltage between 0 and 9V See (URL) (26 years ago, 30-Nov-98, to lugnet.trains)
|
|
| | Re: Track Switch solenoids
|
|
On Thu, 19 Nov 1998 01:39:31 GMT, Larry Andersen <neonglass@earthlink.net> wrote: :My problem with using pneumatics for the job is that the pistons stick :after sitting for a while. You have to break them loose manualy before :they will work (...) (26 years ago, 30-Nov-98, to lugnet.trains)
|
|
| | Re: 9V Speed Regulators
|
|
On Thu, 19 Nov 1998 04:24:02 GMT, Mark Harrison <harro1@one.net.au> wrote: :The reason this is of interest to me is that I have always wanted to use :12V lighting sets with my 9V setup but as the regulators always said :9-10V I thought it would not (...) (26 years ago, 30-Nov-98, to lugnet.trains)
|
|
| | Re: A better boxcar? (was: Re: Thanks to Terry Cruse and Ali V.
|
|
On Fri, 6 Nov 1998 20:42:39 GMT, "Dan Parker" <danp@qi2.com> wrote: :I must agree with Ben -- and this might be a little more blunt. As much of a :LEGO trainhead that I am, I find it difficult to justify building a shrine to :the 9v series in its (...) (26 years ago, 30-Nov-98, to lugnet.trains)
|
|
| | Re: A new diesel by Ben
|
|
Yes, it uses two 1x2/1x4 angle brackets. both attach to a 2x6 plate. The two medium slopes attach to either side and a non rotating magnet base attaches to the middle with a couple of 2x2 plates to space it out far enough. The upper angle bracket (...) (26 years ago, 30-Nov-98, to lugnet.trains)
|
|
| | Re: A new diesel by Ben
|
|
The color scheme is Red (main body), with yellow,blue,yellow striping. I consider the model a prototype. I'd like to build another based on the same body to reflect a actual freight engine. <snip> (...) (26 years ago, 30-Nov-98, to lugnet.trains)
|
|
| | Re: A new diesel by Ben
|
|
Thanks Tony. Thats pretty high praise since you seem generally pretty reserved about giving it. (...) (26 years ago, 30-Nov-98, to lugnet.trains)
|
|
| | Re: A new diesel by Ben
|
|
Ben Fleskes wrote in message ... (...) locomotive. (...) Nice work. I've admired your other designs in silence, but now I feel the time has come to say: you are one talented motherfucker. Keep up the good work. (26 years ago, 29-Nov-98, to lugnet.trains)
|
|
| | Re: A new diesel by Ben
|
|
(...) OK, I did some more digging. The GM site is pretty sparse but check out this link: (URL) right picture (the SD70 MAC) also looks like your loco, same bulging rear radiators. GM and GE are getting harder to tell apart these days. Note that the (...) (26 years ago, 29-Nov-98, to lugnet.trains)
|
|
| | Re: A new diesel by Ben
|
|
(...) I like it. The truck mounted front coupler with side slopes is a good idea, how'd you do it? 1x2/1x4 angle bracket? Note that I have a body mounted front coupler that looks similar on big red... but it's not very sturdy. How sturdy is yours? (...) (26 years ago, 29-Nov-98, to lugnet.trains)
|
|
| | Re: A new diesel by Ben
|
|
(...) Very handsome! The colors on my monitor appear off. Is the bulk of the body red? Make it a good day, Louise (26 years ago, 29-Nov-98, to lugnet.trains)
|
|
| | Re: sticker shock
|
|
(...) (used Lionel purchased at trains shows)I realized very quickly they are too expensive, take up too much space, and have limited play value. Once I screwed the track down so the train would run well, my design options were limited. With Lego I (...) (26 years ago, 29-Nov-98, to lugnet.trains)
|
|
| | Re: sticker shock
|
|
(...) and (...) Fully agreed. I see this all the time at the train shows PNLTC goes to. People spending small fortunes to buy an engine or a car simply to run it around a track. Well I like the building (and rebuilding) aspect of Lego. One of the (...) (26 years ago, 29-Nov-98, to lugnet.trains)
|
|
| | A new diesel by Ben
|
|
Hello all: Used a couple of innovative building techniques for a new diesel locomotive. Check it out and let me know what you think. (URL) can someone please tell me what type of diesel it looks most like? (Larry P?) Thanks a bunch. Ben (26 years ago, 29-Nov-98, to lugnet.trains)
|
|
| | Re: sticker shock
|
|
(...) While competition is a good thing, and TLG has a monopoly on trains that are compatible, it should be noted that there is a lot of junk out there in the regular train hobby, especially in HO and in the large scales. I see so many families (...) (26 years ago, 28-Nov-98, to lugnet.trains)
|
|
| | sticker shock
|
|
Once in while it is a good idea for me to wander through a train/hobby store to remind myself why I switched to Lego trains. The prices for new sets are outrageous! $50 for one hand pump car is way too much, even if the polar bears on it are cute. (...) (26 years ago, 28-Nov-98, to lugnet.trains)
|
|
| | Re: Zany Brainy train exclusive-Cheap 4565 FRIDAY ONLY
|
|
(...) I got one of the 2 remaining at the San Mateo, CA Zany. (...) The 5571 were marked at $139.99 and were $111.99 after discount. The sale excludes Mindstorms. It was interesting that the 8428 Turbo Command didn't ring up with the sale price, but (...) (26 years ago, 27-Nov-98, to lugnet.trains)
|