Subject:
|
Re: Random Pneumatic idea/question
|
Newsgroups:
|
lugnet.technic
|
Date:
|
Wed, 23 Nov 2005 12:29:00 GMT
|
Viewed:
|
4973 times
|
| |
|
|
In lugnet.technic, Billy Bauman wrote:
<snip>
>
> Yes, I was wondering what method should be used to bleed them successfully. The
> clamp idea is a good one. My compressor is very basic. I don't have buggy
> motors. To build the pressure/vac engine all you would have to do, I assume, is
> split the lines going to the engine switch valves so that the engine switches in
> sync with the pistons. Right? kind of like this...
> http://www.fifth-r.com/cssoh1/control.htm
> Also, I'm wondering if, because of how slow the compressor may work, that two
> cylinders should be linked together so that a larger volume of air/vac/oil could
> be moved.
> I'm trying to think of how to install a resivoir system for the hydraulic
> concept. the problem I have is that, the over flow goes into a resivoir tank
> right? and then cycles back to the pump. If that happens wouldn't the load
> cylinders not recieve the proper propulsion force. If so, wouldn't you have to
> make a pressure valve leading to the tank that would only open if the cylinder
> absolutely couldn't lift the load?
> I'm a little confused right now and I'm going to have to lear a little more
> about how a proper hydraulic system works. I'll also try to improve my
> compressor design.
>
> Billy.
Hi Billy,
As CSSoh points out, there are a few simple diagrams here on page 5 and 6 that
might help clarify hydraulics for you. One thing we're missing is pressure
regulation.
http://www.amazon.com/gp/reader/0750639377/ref=sib_dp_pt/104-9881151-8158322#reader-link
Kevin
|
|
Message has 1 Reply:
 | | Re: Random Pneumatic idea/question
|
| (...) I think that we can make a simple pressure regulator using a piston, a single switch, and rubber bands. The piston is mechanically linked to the switch. Rubber bands compress the piston. When the piston is most contracted, the switch is off. (...) (19 years ago, 23-Nov-05, to lugnet.technic)
|
Message is in Reply To:
| | Re: Random Pneumatic idea/question
|
| (...) Yes, I was wondering what method should be used to bleed them successfully. The clamp idea is a good one. My compressor is very basic. I don't have buggy motors. To build the pressure/vac engine all you would have to do, I assume, is split the (...) (19 years ago, 22-Nov-05, to lugnet.technic)
|
22 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
