| |
>
> The thing is though, 8455s have lots of beams without studs, and ones with studs
> generally seem to be declining. Perhaps I should build more with the beams from
> 8455s. The trouble is, using the right angle brackets to make right angles
> introduces too much flexing into the joints. Beams and plates were much more
> rigid. Rigidity is essential for efficiency, and efficiency increases speed.
I too regret the fact that studded designs are hard to find. There are plenty
of situations where studded bricks are the way to go.
Kevin
|
|
Message is in Reply To:
 | | Re: Pneumatics book?
|
| (...) Yes, I just noticed that it was one of your specialities - obvious due to the picture on the Technic newsgroup page. I also major in trains, which take a lot of time, so I haven't had time to develop pneumatics much for a few years. However, (...) (22 years ago, 9-Apr-04, to lugnet.technic, lugnet.books)
|
38 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
