To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 26147
26146  |  26148
Subject: 
Re: thoughts on gbc module reliability
Newsgroups: 
lugnet.robotics
Date: 
Thu, 29 Jun 2006 20:00:16 GMT
Viewed: 
3768 times
  
"Steve Hassenplug" <Steve@TeamHassenplug.org> wrote in message
news:35326.66.84.205.186.1151609951.squirrel@webmail8.pair.com...
On Thu, June 29, 2006 1:30 pm, Rafe Donahue wrote:
All GBCers,

Thread HiJack!!!!!!

The new Bionicle sets have some shotting balls in them and they are a little
bit bigger than soccer balls (and a little heavier).  Has anyone tried these
with success in a BGC?

Now back to your regularly scheduled thread...

-Rob
www.brickmodder.net



Message has 1 Reply:
  Re: thoughts on gbc module reliability
 
(...) They are a little bigger and a little heavier. If either of these is a problem for your module, then it's a problem. :) They will work with most of my modules, but not all. However, they are good for shooting with an NXT... Steve (18 years ago, 29-Jun-06, to lugnet.robotics)

Message is in Reply To:
  Re: thoughts on gbc module reliability
 
(...) Rafe, It sounds like all this info jammed up in your brain, before it finally leaked out... :) All these thoughts & calculations are good. As you pointed out, for one module, it's ok if 90% of the balls pass through. However, with ten modules (...) (18 years ago, 29-Jun-06, to lugnet.robotics)

43 Messages in This Thread:
















Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR