To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *5046 (+20)
  Subtasks quitting before completing
 
I saw some posts during the last three days about subtasks quitting before completing. I never saw a solution, so I will re-ask the question. If my robot triggers a touch sensor and before it completes all of the commands in that group of commands (...) (28 years ago, 9-Nov-98, to lugnet.robotics)
 
  Re: Spirit.ocx manual
 
Marshall Williams wrote in message <01BE0BB7.9F1AB180.M...tt.net>... (...) You may want to check out: (URL) Brok Visit LEGO ON MY MIND: (URL) section: (URL) (28 years ago, 9-Nov-98, to lugnet.robotics)
 
  Re: Subtasks quitting before completing
 
(...) The confusion is because only instantiation of each stack can be active at a time. If you start a stack that is already running, that stack stops, then restarts. The rule for conflicting signals is that the last one set has precedence. So if (...) (28 years ago, 9-Nov-98, to lugnet.robotics)
 
  Re: Subtasks quitting before completing
 
(...) This weekend I built a 4x4 rover with two front bumper sensors. I was faced with the problem of both sensors triggering at the same time. My fix was to set the counter to 1 and add a stack controller to check the counter before turning the (...) (28 years ago, 9-Nov-98, to lugnet.robotics)
 
  Firmware: IR transmission demystified
 
IR transmission was pretty tough to get at. Carrier frequency was the final key - there are no crystals to create the IR carrier, so the processor has to provide it. It turns out that 8-bit t1 output is used for just that purpose. Guess I'll have to (...) (28 years ago, 9-Nov-98, to lugnet.robotics)
 
  Re: Solar-powered RCX?
 
I think the RCX will use which ever supply voltage is greater. I havn't tested this, but I'll bet that when you plug the AC adapter into the RCX when the AC adapter is not even plugged into the wall the RCX will still work. This means there isn't a (...) (28 years ago, 9-Nov-98, to lugnet.robotics)
 
  Re: Solar-powered RCX?
 
(...) I'm almost positive that the RCX uses whichever is greater, within a diode drop somewhere. But even still, I imagine that there is some leakage current from the batteries. Or maybe I was imagining that, and my batteries did not really drain. (...) (28 years ago, 9-Nov-98, to lugnet.robotics)
 
  Re: Cybermaster Spirit.OCX and Visual Basic
 
In message <3.0.5.32.1998100914...elia.com>, Ole Christian Gulbrandsen <olechr.gulbrandsen@....telia.no> writes (...) Thanks. :-) I was referring to the possibility that the interpreted source code may be too slow to communicate effectively with the (...) (28 years ago, 9-Nov-98, to lugnet.robotics)
 
  cybermaster case
 
I have a cardboard case with plastic handles. Apparently it should be a nice aluminium one. Does anybody know why this is? Will it be a collectors item? :-) (28 years ago, 9-Nov-98, to lugnet.robotics)
 
  Re: Multiple Cybermasters
 
This is an important consideration as over here in the UK, we have a robot wars program currently showing on BBC TV where contestants control their creations in an arena via radio control. Note that this is not the same as two autonomous computers (...) (28 years ago, 9-Nov-98, to lugnet.robotics)
 
  RE: Firmware: IR transmission demystified
 
I'm curious, and sorry if this has come up before: Any chance someone can get the RCX to communicate with IrDA devices? I'm thinking specifically of small hand-held computers. I don't know much about infrared data transmission, but it based on (...) (28 years ago, 9-Nov-98, to lugnet.robotics)
 
  Re: Firmware: IR transmission demystified
 
(...) Briefly remind me of what the IrDA signal is like and I might be able to answer. -Kekoa (28 years ago, 9-Nov-98, to lugnet.robotics)
 
  Re: Firmware: IR transmission demystified
 
I just checked (URL) The physical link layer is based on the common asynchronous serial (...) If our baby can recognize those 3/16 marks as marks, and the other end won't mind our transmitting 16/16 marks, perhaps. (URL) IrDA physical layer (...) (28 years ago, 10-Nov-98, to lugnet.robotics)
 
  Re: Solar-powered RCX?
 
Along the same line, does anyone have the specs on the co-ax power plug itself? diameter (outside & inside) and the polarity? I dont want to fry my brick through experimentation... Thanks, Tom (determining if there is circuitry involved should have (...) (28 years ago, 10-Nov-98, to lugnet.robotics)
 
  Re: Solar-powered RCX?
 
(...) A plug that fits, with either polarity, 9-12V, ought to work fine. Capacitors and a rectifier do the conversion for you. Be careful, but don't worry about it too much. (...) As far as I know, it's not this simple. There is no mechanical (...) (28 years ago, 10-Nov-98, to lugnet.robotics)
 
  Help with my IR tower
 
Hello everyone, I've had my Mindstorms for about 2 months now. When I first got it everything worked fine, I downloaded the firmware, and my own programs (from the Mindstorms software), but then other pressures forced me to put them away until now. (...) (28 years ago, 10-Nov-98, to lugnet.robotics)
 
  RE: Help with my IR tower
 
(...) Well, the first thing to check is if the green LED inside the tower is lighting up when it tries to talk to the RCX. If it is, you know its a tower->RCX problem, if not, it's a PC->tower problem. -Allen (28 years ago, 10-Nov-98, to lugnet.robotics)
 
  Re: What are you making?
 
(...) The base works quite well. I used NQCC to program the RCX and it now runs in almost perfect squares. Really cool. I'll have to do more with it later but this was a first stab at using NQCC (many thanks to Dave Baum for this gem). -- Doug (28 years ago, 9-Nov-98, to lugnet.robotics)
 
  Re: Multiple Cybermasters
 
CyberUser wrote in message ... (...) I see. It should be clear to the reader that *only* Crusher is computer controlled! Stinger is just a mechanical 'hammer' that the kid holds in his/her hand to slam at Crusher manually. Eric Brok Visit LEGO ON (...) (28 years ago, 10-Nov-98, to lugnet.robotics)
 
  Re: Cybermaster Spirit.OCX and Visual Basic
 
CyberUser wrote in message ... (...) Programs are downloaded in units (tasks or subs). Mind Control automatically pauses briefly after each EndOfTask or EndOfSub statement for the download of this unit to end before the next download starts. (...) (28 years ago, 10-Nov-98, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR