 | | BrickFest DC 2005 Technic/Mindstorms events
|
|
BrickFest is coming and the robots are getting restless! Competition robots that is. Yes, BrickFest is just two months away and its time to start tuning up your competition robots. There are four competitions this year, look at (URL) for more info. (...) (21 years ago, 5-Jun-05, to lugnet.announce, lugnet.build.contests, lugnet.events, lugnet.events.brickfest, lugnet.fun.community, lugnet.general, lugnet.technic, lugnet.robotics) !!
|
| |
 | | Re: BT in robotics
|
|
(...) That's happened since we got our office contract. I'll check into it, thanks. If it's $19 for as much as you can stand to use, that's not so bad. We were paying $10-$20 for a couple of megabytes per month. But the phones are so slow I don't (...) (21 years ago, 5-Jun-05, to lugnet.robotics)
|
| |
 | | Re: Blocking SetUserDisplay?
|
|
(...) That's the only way around it as far as I know. JB (21 years ago, 4-Jun-05, to lugnet.robotics.rcx.nqc)
|
| |
 | | Blocking SetUserDisplay?
|
|
I have a program with a setup routine for calibrating light sensors. During the setup routine, it does: SetUserDisplay (a, 2); Then in a loop, reads the values of 2 light sensors into x & y, averages the readings and then does: a = x * 100 + y; to (...) (21 years ago, 4-Jun-05, to lugnet.robotics.rcx.nqc)
|
| |
 | | Re: BT in robotics
|
|
Bruce, 1. Yeah, SonyEricsson is very serious about their Linux robot 2. How else (other than Bluetooth) could you send data from your cellphone to your robot? IR isn't an ideal solution, since a lot of phones don't support it. 3. I created the (...) (21 years ago, 3-Jun-05, to lugnet.robotics)
|
| |
 | | Re: for robots and industry: BlueTooth bad, Zigbee good - thanks for response
|
|
Bruce, 1. True, Bluetooth is embedded in a lot of cellphones. But cellphones is not the only device that carries Bluetooth, as you already know. However, SonyEricsson has created the ROB1, which is a Linux robot that is controlled by Bluetooth, (...) (21 years ago, 3-Jun-05, to lugnet.robotics)
|
| |
 | | Some BT modules?
|
|
Some more googling reveals some possible BT embedded modules: (URL) From the above page: EmbeddedBlue brings the benefits of Bluetooth technology to all embedded systems from low power 8-bit micros to the latest 32-bit processor powerhouses. With (...) (21 years ago, 3-Jun-05, to lugnet.robotics)
|
| |
 | | Re: BT in robotics
|
|
(...) Use the data capability of the phone to set up their equivalent of an IP connection. On my TMobile phone this is painfully slow, under 100 kbits at best, often less than 50 kbits, even when literally next door to a cell. I did some tests with (...) (21 years ago, 3-Jun-05, to lugnet.robotics)
|
| |
 | | BT in robotics
|
|
(...) I'd love to have my cell phone give me status and feedback from my robots. BT isn't the only way to do this, of course, and using the cellular data capability of the phone would allow connecting from around the world, not just within 10 (...) (21 years ago, 3-Jun-05, to lugnet.robotics)
|
| |
 | | Re: Bluetooth etc.
|
|
(...) The journal is extensively long... We abandoned the idea of I2C access control to the camera module. Instead we switched to the CMUCam2 module, that operates some useful image preprocessing. The communication is ordinary serial. (...) Negative (...) (21 years ago, 3-Jun-05, to lugnet.robotics)
|
| |
 | | Re: Bluetooth etc.
|
|
Quoting Claude Baumann <cbaumann@ci.educ.lu>: (...) the camera, not the data from the camera? (...) There's a lot of detail about how BT works here (in German). If I understand the schematics, the BT hardware is one of the serial-to-BT adapters, so (...) (21 years ago, 3-Jun-05, to lugnet.robotics)
|
| |
 | | Bluetooth etc.
|
|
As I announced earlier, we are still working on the "directly wiring a camera..." project. Things work very well now and the project was and still is a great occasion in learning more. (URL) "learning" is the bulk of the Mindstorms project, learning (...) (21 years ago, 3-Jun-05, to lugnet.robotics)
|
| |
 | | BT headsets and...
|
|
(...) My remarks were made comparing the power use of advertised BT chips vs 900-MHz and 2.4 GHz RF chip sets based on what was available a couple of years ago. To answer your question about headsets, I will speculate since I don't really know. But (...) (21 years ago, 3-Jun-05, to lugnet.robotics)
|
| |
 | | Re: for robots and industry: BlueTooth bad, Zigbee good - thanks for response
|
|
I have watched this thread for a while, but not "joined in" as I am not personally familiar with implementing Bluetooth. However, I have a question about the assertion that Bluetooth necessarily requires high power consumption; How well do coin cell (...) (21 years ago, 3-Jun-05, to lugnet.robotics)
|
| |
 | | Re: for robots and industry: BlueTooth bad, Zigbee good - thanks for response
|
|
(...) I should have made it more clear that all my BT remarks were in the context of use in the industrial or embedded spaces such as robotics where we get access to the hardware. Sure, millions of BT cell phones are shipping, but that's no help to (...) (21 years ago, 2-Jun-05, to lugnet.robotics)
|
| |
 | | Re: wireless sensors, and battery life: time synch
|
|
(...) Yes -- and this is exactly Zigbee's target. BT was originally aimed at PC, PDA, peripheral communication, and it could have done well at that. Now I think it is eclipsed by the low cost and 10-100X better speed of 801.11b/g. Zigbee has from (...) (21 years ago, 2-Jun-05, to lugnet.robotics)
|
| |
 | | Re: position calculating for robots
|
|
(...) There are various geometries have been implemented in Lego bricks for this. Here is one example: (URL) searching Google for "Lego adder subtractor" for others. (21 years ago, 2-Jun-05, to lugnet.robotics.rcx.legos)
|
| |
 | | Re: Nemesis4Lego controller
|
|
On Jun 1, 2005, at 7:31 PM, Gabriel Petrut wrote: <SNIP> (...) Gabe is correct, you can now find his page hosted by the LEGO Robotics Group of Ann Arbor at the following URL: (URL) (21 years ago, 2-Jun-05, to lugnet.robotics)
|
| |
 | | Re: Nemesis4Lego controller
|
|
(...) Joe, the controller, as it is built right now, has two 3 pin ports exacly for sensors like ultrasonic, Sharp SP2D12, compass, accelerometer, etc. and servos. And I have in the works a module with a serial LCD. About my site. I just cheked it (...) (21 years ago, 1-Jun-05, to lugnet.robotics)
|
| |
 | | Re: BlueTooth bad, Zigbee good
|
|
I'm biased, so here's my rebuttal: 1. The JB-22 is a great, affordable Bluetooth development kit under $200 USD. (URL) Class 1 Bluetooth devices have a range of +300ft. Anycom makes one that is rated at 330ft, but tests have shown that it can (...) (21 years ago, 1-Jun-05, to lugnet.robotics)
|