To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *25674 (-20)
  Re: cybermaster set-up problems
 
(...) I doesn't get any simpler than the way you're supposed to do it. Attach the tower to a serial port, install the software, and you're running. Remember to check the battery in the tower, and try to remove it for a couple of secs... Other than (...) (26 years ago, 1-Jan-01, to lugnet.robotics.cybermaster)
 
  Re: Help! I think I nuked my IR transmitter!
 
Usually these circuits are protected against reversed polarity. Does the green light work after the battery was properly installed. Have you succeeded in installing the firmware? Try different settings on the tower switch. Short range and Long (...) (26 years ago, 1-Jan-01, to lugnet.robotics)
 
  Re: Motor Drivers
 
I use the L293D in my Lego Automation Controller. PWM works fine with this chip. (I built several variations of the controller before Mindstorms was available.) - pete. (...) -- Pete Sevcik sevcik@flash.net Techno-stuff Robotics (URL) for FUN ! (26 years ago, 31-Dec-00, to lugnet.robotics)
 
  Re: Help! I think I nuked my IR transmitter!
 
"John Phillips" <buckwheatphillips@msn.com> wrote in message news:G6Hpxs.1uH@lugnet.com... (...) the (...) John, I think you're OK. The 9V terminals inside of the IR Tower are different sizes - one small hole, and one large one (in the plastic (...) (26 years ago, 1-Jan-01, to lugnet.robotics)
 
  Help! I think I nuked my IR transmitter!
 
Hello All, I'm new to all this so please forgive me if I breach any format or protocal. I'm having some trouble with downloading my Mindstrorms 1.0 RCX. Every time I try a message says IR trans. not working. I tried all the suggestions it gave and (...) (26 years ago, 1-Jan-01, to lugnet.robotics)
 
  Cunning idea
 
For anyone annoyed by the lack of motor outputs on the RCX who has some electronic engineering experience, a device can be built using a 4017B decade counter, some relays and a few other parts that will give a total of 1 original motor connection (...) (26 years ago, 1-Jan-01, to lugnet.robotics)
 
  Re: Message transmission speeds.
 
(...) That sounds believable. I send 6 one-byte messages in each comms cycle. That's gotta be a good 150ms - which is probably about what I'm seeing. How depressing. :-( (...) So, the first major speedup would be to send a 3-byte message containing (...) (26 years ago, 1-Jan-01, to lugnet.robotics)
 
  Re: Error in grabber arm instructions?
 
I just recently built the grabber arm with my new RIS 1.5 set, and I didnt have any problems with not having enough pieces. If i get time later ill see how many 6-length bars my set has, but I had plenty to build the grabber arm as far as i can (...) (26 years ago, 1-Jan-01, to lugnet.robotics)
 
  Re: how long can i keep the rcx on
 
(...) I have recently used my RCX with a Train Transformer and ran it for 10 days. No worries. Dean -- Coin-Op's For Sale!: (URL) Lego Workshop: (URL) Lego Club: (URL) (26 years ago, 1-Jan-01, to lugnet.robotics)
 
  Re: Error in grabber arm instructions?
 
I too Had this problem. I had 8 w/ a length of six. I had to substitute these parts. I wonder why?? I have the 1.5 RCX also. (...) (26 years ago, 1-Jan-01, to lugnet.robotics)
 
  Error in grabber arm instructions?
 
I've got an RIS 1.5 set, and I'm building the grabber arm from the instructions on the Lego website. The instructions call for a total of 10 beams of length 6 (is there a standard terminology for these things?), and my set only has 8. I'm (...) (26 years ago, 31-Dec-00, to lugnet.robotics)
 
  Re: how long can i keep the rcx on
 
patel <lego-robotics@crynwr.com> wrote in message news:003301c073b1$63...default... Dear Group Can i keep it on for many hours?? There is an automatic time out that you need to set to 0. After that it should run forever on AC. (26 years ago, 31-Dec-00, to lugnet.robotics)
 
  Re: LNP - LegOS Network Protocol
 
(...) It is now. :) I'm guessing you're seeing an outdated copy of the HOWTO, as there's now a decent section about LNP. But don't take my word for it, since I'm kind of biased, being the author of that particular section. Anyway, you can jump (...) (26 years ago, 31-Dec-00, to lugnet.robotics.rcx.legos)
 
  LNP - LegOS Network Protocol
 
I have just switched from NQC to LegOS and need to write some messaging code. However the this section of legOS is not very well documented. LNP - LegOS Network Protocol Don't have much information about this section yet, anyone who can shed some (...) (26 years ago, 31-Dec-00, to lugnet.robotics.rcx.legos)
 
  Black Square Problem
 
On the top row of the LCD I have black squares, like the problem listed in the FAQ, but none of the info in the FAQ helps. I can download p_code in the 'dl' program but not 'HBDL'. Occaisionally when I turn it on all the red indicators on the motor (...) (26 years ago, 31-Dec-00, to lugnet.robotics.handyboard)
 
  English version of VC software - where, from?
 
Hello. I am new to LEGO Mindstorms world. I live in Poland where LEGO is not selling its Vision Command extension to Mindstorms. I have it bought in Germany. Unfortunately the software included in a.m. set was localized, and is available only in (...) (26 years ago, 31-Dec-00, to lugnet.robotics.vc)
 
  Motor Drivers
 
Hi, Currently I'm using an L298 to drive a couple of DC motors. Unfortunately the only way I can intorduce any sort of speed control is to PWM the enable line since PWM'ing the inputs for speed control does not work. Does anyone else know of any (...) (26 years ago, 31-Dec-00, to lugnet.robotics)
 
  Re: Message transmission speeds.
 
In the RCX and the tower, the IR receiver is located close to the transmitter. When the transmitter is running, the adjacent receiver's Automatic Gain Control cirucit (AGC) becomes saturated, and sets the receiver sensitivity to it's lowest possible (...) (26 years ago, 30-Dec-00, to lugnet.robotics)
 
  (canceled)
 
 
  (canceled)
 

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR