To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *13366 (+20)
  Club San Franlego
 
browsing around the "Lego Robotics Laboratory" web site (URL) I came across a link for the Club San Franlego, one can only assume that this is a club for lego fans in San Francisco and since this is my home town I would be very interested in (...) (27 years ago, 10-Aug-99, to lugnet.robotics)
 
  Re: Droid Developer Kit is here
 
(...) What you're actually trying to say, is that the light sensor would generate a pulse each revolution, not each minute. The RCX has to measure the minutes internally, the light sensor would measure the revolutions. You could also have the light (...) (27 years ago, 10-Aug-99, to lugnet.robotics)
 
  Micro Scout light sensor (was Re: Droid Developer Kit is here
 
(...) Most "light sensors" are sensitive to the light put out by IR remote controls and other devices with standard IR-emitting diodes. It's actually more expensive to make a light sensor that does *not* pick up IR wavelengths. Therefore, it's (...) (27 years ago, 10-Aug-99, to lugnet.robotics)
 
  Re: Building help from TLG
 
----- Original Message ----- From: Ralph Hempel <rhempel@bmts.com> To: <lego-robotics@crynwr.com> Sent: Tuesday, August 10, 1999 11:26 AM Subject: RE: Building help from TLG (...) frame? Two ways: 1) Right click on the frame that you want the URL (...) (27 years ago, 10-Aug-99, to lugnet.robotics)
 
  IR-Tower and PowerBook-G3 ?
 
Has anyone else had problems using the IR-Tower with a PowerBook-G3 (WallStreet '98)? I tried for two days and only got 'Problem talking to IR device' messages. Tried different cables, cont-checked both cables. Finally went and tried it on the GFs (...) (27 years ago, 10-Aug-99, to lugnet.robotics.rcx.nqc)
 
  FW: Building help from TLG
 
(...) (URL) DUH!! You are right. I DO know about right clicking, I'm just so used to going to a site and having the URL up there in the window WHERE IT IS SUPPOSED TO BE!!! PS, Thanks to all the others that responded so quickly...what a friendly (...) (27 years ago, 10-Aug-99, to lugnet.robotics.rcx)
 
  Re: Darn those definitions (was: The new Super Car)
 
(...) Dear Mister Dantic, I am sure you carefully thought out your statement about compressibility, but I must point out your intolerably egregious oversights. Specifically, here are several things that cannot be compressed: - Massless particles (...) (27 years ago, 10-Aug-99, to lugnet.robotics)
 
  RE: IR-Tower and PowerBook-G3 ?
 
(...) This might sound stupid, but did you try it with the G3 attached to a wall wart? The reason I mention this is that my digital camera only downloads to my laptop if the laptop is plugged in to the wall. The laptop serial levels DO change (...) (27 years ago, 10-Aug-99, to lugnet.robotics.rcx.nqc)
 
  Re: Building help from TLG
 
(URL) is accually in the extreme creatures set. Can't believe I accually paided 54 bucks for that ......... KGB AgEnT #4 OUT AKA Clint Rutkas -- Did you check the web site first?: (URL) (27 years ago, 10-Aug-99, to lugnet.robotics)
 
  putting liquid into pneumatic elements (was Re: Darn those definitions (was: The new Super Car)
 
(...) The pneumatic compression cylinders, also called "pumps" are not airtight, and they wouldn't be watertight if filled with water. When you push on them they would apply pressure to the water all right, but when you pull on them they would (...) (27 years ago, 10-Aug-99, to lugnet.robotics)
 
  Re: I/o's expansions for the mindstorm ?
 
(...) This might not be relevant for everyone out there, but I thought I'd point out: If you use a learning remote to learn the codes from the MindStorms remote control, please note that all combinations of the three motor controls send out a (...) (27 years ago, 10-Aug-99, to lugnet.robotics)
 
  Re: new products (Remote Control)
 
(...) 1 Send message "1" 2 Send message "2" 3 Send message "3" A^ Run motor A in > direction (see notes below) Av Run motor A in < direction (see notes below) B^ Run motor B in > direction (see notes below) Bv Run motor B in < direction (see notes (...) (27 years ago, 10-Aug-99, to lugnet.robotics)
 
  Re: IR-Tower and PowerBook-G3 ?
 
(...) Yes. The PB-G3 is plugged into a wall-wart almost all the time. I thought of that also. Very strange. I'm resurecting an old SE/30 in the hopes that I can squeeze MPW into an 8MB machine. I think the serial ports on that machine ought to be (...) (27 years ago, 10-Aug-99, to lugnet.robotics.rcx.nqc)
 
  Re: Pnuematics: e-switch and thoughts
 
(...) If you use a t-connector to connect each side of the circuit to a compressor (that uses a SMALL pump and NO tank!) you can maintain high pressure, and the fact that the pump's cylinder is small compared to the other two cylinders means that (...) (27 years ago, 10-Aug-99, to lugnet.build, lugnet.robotics)
 
  Re: Pnuematics: e-switch and thoughts
 
(...) That link doesn't work anymore. Can anyone tell us how this construction worked? (any gears? Levers? Maybe a worm gear?) I might want to use the idea in a Mindstorms design. (by the way, I really liked the soda bottle tank idea and might try (...) (27 years ago, 10-Aug-99, to lugnet.build, lugnet.robotics)
 
  Re: new products (Remote Control)
 
The remote is really handy when checking your creations before you program them. I use mine all the time. Also fun to run little cars and other bots. Even used it to drive my 8448 Street Sensation about the house. Bob Fay rfay@we.mediaone.net The (...) (27 years ago, 10-Aug-99, to lugnet.robotics)
 
  RCX Firmware storage.
 
After a near heartattack with my TI-89 after upgrading it's flash ROM (I think it is flash rom, Flash Somethin, (URL) I have to ask myself what exactly does the RCX have to store the Fireware. After pulling all avaible power source to my TI-89, it (...) (27 years ago, 10-Aug-99, to lugnet.robotics)
 
  Re: IR-Tower and PowerBook-G3 ?
 
(...) I use the IR tower with a Wallstreet regularly (NQC was developed on my PowerBook), and I haven't had any problems. Did you make sure that AppleTalk is either set for Ethernet or turned off completely? You also may want to disable other (...) (27 years ago, 11-Aug-99, to lugnet.robotics.rcx.nqc)
 
  Re: NQC (Mac) and KeySpan card?
 
(...) Yes, but you need to know the name of the device driver, and this is usually pretty difficult to find. Serial ports use two separate drivers - one for input and one for output. Usually the names are something like this: ".xxxIn" and ".xxxOut" (...) (27 years ago, 11-Aug-99, to lugnet.robotics)
 
  Re: RCX Firmware storage.
 
(...) microcontroller's on chip ROM. The other half (which gets downloaded) isn't really firmware. Its stored in SRAM that is powered from the main batteries. If you take out the batteries the firmware will be lost after a few minutes. If you want (...) (27 years ago, 11-Aug-99, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR