To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *10736 (+20)
  Re: Servo DEinitialization.
 
I'd go for the Coke can idea. Sounds like a surer shot. I thought init_expbd_servos(x), where x = integer from 0 to 5, was used to initialize the servos individually. Stupid me. I've been using init_expbd_servos(5), and, since I only had #5 hooked (...) (28 years ago, 13-Apr-99, to lugnet.robotics.handyboard)
 
  Re: clutch gear
 
(...) No, but it's probably the cheapest, unless it's in a Dacta spare parts kit I don't know about. Target had the 3735s on sale for over 50% off. It's also in the 8479 Bar Code Multi set, but that's $160. These are the only two sets that have it (...) (28 years ago, 13-Apr-99, to lugnet.robotics)
 
  Dark seeker project
 
I have finally built a creation with my Mindstorms kit that uses all of the sensors (some twice) and all of the motor connections! It has two bump switches for a collision detector on the front, one of my RCX IRPD modules to try to detect potential (...) (28 years ago, 13-Apr-99, to lugnet.robotics)
 
  Re: Servo DEinitialization.
 
(...) as it says in the docs: init_expbd_servos(int action) If action is zero, servo control signals are disabled. If action is non-zero, servo control signals are enabled. Control signals are disabled by default every time the Handy Board is reset. (...) (28 years ago, 13-Apr-99, to lugnet.robotics.handyboard)
 
  Re: Servo DEinitialization.
 
Sorry. I'll reread the documentation. I was going by memory. Fred G. Martin Fred G. Martin (...) Ross Tonkens (28 years ago, 13-Apr-99, to lugnet.robotics.handyboard)
 
  Re: **lego motors?**
 
(...) I don't think that it would take up a lot of space at all. In fact, the largest part should be the motor that is used to engage/disengage the gear. Using a tractor hub, two 16-T gears, and two axles (with other parts to hold this all together, (...) (28 years ago, 13-Apr-99, to lugnet.robotics)
 
  Re: **lego motors?**
 
Laurentino Martins wrote in message <4.1.19990412164203....90.220>... (...) gears, with a rubber band pushing it to one of the sides...? There has been a couple of versions of just what you describe, however I don't have the URLs. Sorry... about (...) (28 years ago, 13-Apr-99, to lugnet.robotics)
 
  just to say hi
 
hi (28 years ago, 13-Apr-99, to lugnet.robotics)
 
  Has anyone an icb-routine for 9600b serial connection ?
 
Hi, i used the serialio.c routines to establish a data connection between the Handyboard and a Linux PC and encountered the same problems already mentioned in the mailing list: 1) Only char by char transmission with sleeps between transmissions (...) (28 years ago, 13-Apr-99, to lugnet.robotics.handyboard)
 
  Re: SENSOR_READ doesn't return 0
 
(...) I am just dabbling at the moment, trying a few words to try and get them debugged. In order to fully port the SpeedBot (currently in NQC) I'll need multitasking... (...) Oh, good - I wondered if I'd got versions mixed up somewhere. It would be (...) (28 years ago, 13-Apr-99, to lugnet.robotics.rcx.pbforth)
 
  help about part C3
 
Can anyone tell me of a good place to get part C3 for the handy board?...DigiKey no longer has it or a replacement. -Jon Schuck (28 years ago, 13-Apr-99, to lugnet.robotics.handyboard)
 
  Re: clutch gear
 
(...) What's the clutch gear? Is it the same as the free-wheeling gear which comes in one of the Lego service packs? (either the diff one or the gear blocks one, I forget which) If not, could someone describe it? Stuart -- Did you check the web site (...) (28 years ago, 13-Apr-99, to lugnet.robotics)
 
  RE: clutch gear
 
# From: sc10003@eng.cam.ac.uk # Sent: Tuesday, April 13, 1999 01:47 PM # To: lego-robotics@crynwr.com # Subject: Re: clutch gear # ---...--- # What's the clutch gear? Is it the same as the free-wheeling gear which # comes in one of the Lego service (...) (28 years ago, 13-Apr-99, to lugnet.robotics)
 
  Lego Bots in Germany???
 
Hello List! It seems that Lego refuses to sell the Mindstorms Roboticcs Invention Kit to non-English-speaking countries, allegedly because they don't want to annoy us with an English manual?! The only robotics set available in Germany is this Lego (...) (28 years ago, 13-Apr-99, to lugnet.robotics)
 
  Re: help about part C3
 
use Digikey P6305-ND or P5417-ND. both are 470 uF electrolytics, axial leads (that is, leads sticking out opposite ends) and are 16 mm long and 8 mm in diameter. in other words, they're the right value and they'll fit. F. (...) (28 years ago, 13-Apr-99, to lugnet.robotics.handyboard)
 
  Fwd: Re: help about part C3
 
replying to my own msg... (...) (that is, (...) in other words, (...) ok, so P6305-ND is the part i originally specified. sure enough, you can't find it online. but i found it in the latest print digikey catalog! (i didn't check that it was the same (...) (28 years ago, 13-Apr-99, to lugnet.robotics.handyboard)
 
  U12 on the Handy board.
 
Hi- I am not able to find DS-1233-10 (U12) for the handy board. If anybody knows where I could get it or even a good replacement for it, please inform me. Thanks, Ravi. (28 years ago, 13-Apr-99, to lugnet.robotics.handyboard)
 
  Re: Lego Bots in Germany???
 
(...) Remember, this was supposed to be a kids product. (...) CyberMaster. And you are lucky because you are the only country that sells with an aluminium box, the other countries sell it in a card box. (...) Try these: Mondo-tronics' Robot Store (...) (28 years ago, 13-Apr-99, to lugnet.robotics)
 
  Re: help about part C3
 
Does it have to be these parts? Can you put a few together or even use ceramic, polyester, etc? ---...--- ericson mar Robotics Consultant mar@cooper.edu (212)353-4356 Department of Mechanical Engineering The Cooper Union for the Advancement of (...) (28 years ago, 13-Apr-99, to lugnet.robotics.handyboard)
 
  Re: Lego Bots in Germany???
 
(...) The same in Italy where I live. (...) Mindstorm is, IMHO, absoulutely worth to buy. You can find it at $219 (if I remember well) at www.legoworldshop.com. They're not cheap but accept credit card, ship worldwide and have a very good service. (...) (28 years ago, 13-Apr-99, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR