Subject:
|
Re: Rope & Plexi revisited
|
Newsgroups:
|
lugnet.org.ca.vlc
|
Date:
|
Tue, 7 Aug 2001 20:56:04 GMT
|
Viewed:
|
1186 times
|
| |
|
|
Robin Sather wrote:
> We had been thinking of a 6 inch wall of plexi all around. Assuming
> our current layout, and some sort of wooden frame around the plexi (or
> at least on the bottom), we'll have a minimum height of a full 6
> inches from the table top. We can cut all the panels we need from 1
> 4' x 8' sheet of plexi.
6" inches would be good. I've been looking over the pics of the PNLTC tables and
noticed a few things.
They are using tables similar to mine but are thicker wood on top and have folding
legs attached. They use PVC pipe on the legs to match the height to 36". The PVC
can also be different lengths for water, and what not. They also BOLT the Plexi
directly to the tables. At 6 inches high (I'm assuming the actual plexi is higher
to be ok for the table length plus the viewing area).
I think, in the long run, this type of table could be a good idea for the club to
own as a whole. Our tables are very nice but them legs start to be a pain.
ATTACHED legs sound like a dream. But make the tables heavier.
Dean
|
|
Message has 1 Reply:
Message is in Reply To:
 | | Re: Rope & Plexi revisited
|
| (...) Nothing is silly. All your points are extremely valid. I think we should pursue the discussion, decide, and make it happen. (...) We had been thinking of a 6 inch wall of plexi all around. Assuming our current layout, and some sort of wooden (...) (23 years ago, 7-Aug-01, to lugnet.org.ca.vlc)
|
9 Messages in This Thread:
   
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
