Subject:
|
Re: Cutting "Moon surface" baseplate? (Was: 8x16 baseplate colors?)
|
Newsgroups:
|
lugnet.general
|
Date:
|
Wed, 4 Apr 2001 11:50:48 GMT
|
Viewed:
|
528 times
|
| |
|
|
In article <GB8L2u.BBJ@lugnet.com>, Jason Julich <jjulich@vaxxine.com> wrote:
> I’m not going to cut my old 50x50, instead I think I might use an old 32x32
> “moon surface” baseplate. I have three, all are old and yellowing and when
> I was a kid I colored in the craters of two of them with a black permanent
> marker. I never use these, so, unless the “moon surface” baseplates are
> super rare, I think I will just cut up the worst one of the three to get my
> 8x16 light gray baseplate. But then again, I might just go out and buy a new
> 48x48 or something smaller an cut it.
I dunno if I'd say "super rare", but I have none in my collection. I
wouldn't mind trying to salvage yours and would be more than happy to
trade you a 48x48 for it. :)
-JDF
--
J.D. Forinash ,-.
foxtrot@cc.gatech.edu ( <
The more you learn, the better your luck gets. `-'
|
|
Message has 1 Reply:
Message is in Reply To:
13 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
