Subject:
|
Re: New parts for 2001?
|
Newsgroups:
|
lugnet.general
|
Date:
|
Fri, 27 Oct 2000 06:35:59 GMT
|
Reply-To:
|
SSGORE@SUPERONLINE.COMsaynotospam
|
Viewed:
|
762 times
|
| |
|
|
Tom Stangl wrote:
>
> Looks to me like a plastic sheet, and the holes at each corner (and middle) fit
> over Technic "ball and socket" pins - look carefully on the INSIDE of it at the
> top, you can see the holes of a Technic beam showing through the sheet.
It's true for the Mars transport aircraft, but in 7106, I don't think
so. Besides I think 7106 utilizes the same part that used in Alpha Team
bad guys base set. Look at the part between stupid rocket launcher
vehicle and the prison cage. The part is just under the living dead
standing besides the small helo thingy.
Selçuk
> Eric Kingsley wrote:
>
> > In lugnet.general, Bob Hayes writes:
> > > In lugnet.general, John Kornhaus writes:
> > > > Looks like cool new parts for '01:
> > > > ...
> > > > http://collectibles.echostation.com/fbtb/2/sys16.jpg
> > > > 7127 Ack! Looks horrible, but a cheap source for Wookies. Are those
> > > > non-chromed lightsabre handles used for the "nose" guns?
> > > >
> > > > 7186 Looks good for green parts and a big 8x8 round plate not seen for
> > > > a few years.
> > > >
> > > > 7106 8x8 cylinder? Gimme!
> > >
> > >
> > >
> > > I have spent some time looking at 7106
> > > (http://collectibles.echostation.com/fbtb/2/sys16.jpg). Could the large
> > > cylinder be a plastic wrap? It would be a disapointment.
> >
> > Possible but I don't think so. If you look closely at the bottom of the
> > cylinder you can see cutouts for studs so my guess is that it is good old ABS.
> >
> > Eric Kingsley
>
> --
> | Tom Stangl, Technical Support Netscape Communications Corp
> | Please do not associate my personal views with my employer
|
|
Message has 1 Reply:
 | | Re: New parts for 2001?
|
| (...) Good eye on that one. Yes, I think it looks like a 1/4 8x8 cylinder panel in the Alpha Team base. Also in 7106, notice how the cylinder perfectly follows the curve of the bottom 8x8 round plate. I don't think a plastic sheet would be able to (...) (24 years ago, 27-Oct-00, to lugnet.general)
|
Message is in Reply To:
| | Re: New parts for 2001?
|
| Looks to me like a plastic sheet, and the holes at each corner (and middle) fit over Technic "ball and socket" pins - look carefully on the INSIDE of it at the top, you can see the holes of a Technic beam showing through the sheet. (...) -- | Tom (...) (24 years ago, 26-Oct-00, to lugnet.general)
|
25 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
