Subject:
|
Re: LDGLite colour bug
|
Newsgroups:
|
lugnet.cad.dev
|
Date:
|
Thu, 3 Jan 2002 16:00:02 GMT
|
Viewed:
|
503 times
|
| |
|
|
In lugnet.cad.dev, Jacob Sparre Andersen writes:
> The problem seems to be Alpha specific. :-(
Are you sure it's using the fixed part on the Alpha? Perhaps
there is a copy of the old bad part on the search path before
the fixed copy. You could check this by using the ledit mode
to step through the part to make sure it loaded the correct one.
ldglite -LEDIT 2357.dat
Hit pgdn many times to verify that it contains the added inside
surfaces.
If it's really an Alpha specific bug, then I might need a picture.
Does it look different from the problem with the bad part?
Don
|
|
Message has 1 Reply:
 | | Re: LDGLite colour bug
|
| (...) Yes. It is - as I wrote - the cylinders inside the bricks that have the colour of the preceding part. The following is the picture I get, when I render the example with the command `ldglite -q -ms -l3 -s4 -a1,0,1,-0.5,-1,0.5,1,0,-1 (...) (23 years ago, 3-Jan-02, to lugnet.cad.dev)
|
Message is in Reply To:
| | Re: LDGLite colour bug
|
| (...) Same example, but a different problem. :-) (...) :-) No. It was Steve's publishing of a fresh parts release that got me started looking through my old bug reports. For some reason I hit "q" while looking at the example from my old bug report, (...) (23 years ago, 3-Jan-02, to lugnet.cad.dev)
|
14 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
